Abstract:In this study, a comprehensive system-level model was developed for a proton exchange membrane fuel cell (PEMFC) system with a dead-ended anode (DEA) mode. The global system model consisted of a series of local component models, including PEMFC stack, manifolds, air compressor, humidifier and valves. Membrane water conversion and N2 crossover were simultaneously considered in the stack component model. Based on the system-level model, the output voltage and water content of the PEMFC and the compressor power consumption at various currents and ambient pressures were investigated. Additionally, the dynamic behaviors of the cell voltage, its water content, and system hydrogen utilization rate were predicted for two legislated driving cycles-the New European Driving Cycle (NEDC) and the Worldwide Harmonized Light Vehicle Test Procedure (WLTP). The fuel cell voltage fluctuation owing to the anode purge occurred with an increase in the load current. Increasing the ambient pressure increased decay rate and recovery rate of the cell voltage, improved membrane hydration, and lowered the compressor power consumption. For the variable loads of the NEDC and WLTP, the fuel cell voltage and power fluctuated significantly. The membrane water content was controlled by the current in the low-current zone (i < 0.5 A cm-2) and was dominated by the high airflow in the high-current zone (i > 0.9 A cm-2). In the medium-current zone (0.5 A cm-2 < i < 0.9 A cm-2), the membrane water was saturated. The water vapor exhibited a dynamic behavior similar to that of the membrane water; the behavior fluctuated in low and high current zones and stabilized in the medium current zone. The liquid water fluctuated significantly in each current zone of the NEDC and WLTP. Additionally, the H2 utilization rates under NEDC and WLTP were greater than 99%. The developed global system model helps to understand the transient behaviors of a DEAmode PEMFC system and improves the system responsibility for fuel cell system design and development.

A hierarchical model for automotive PEM fuel cell system comprehensive evaluation and comparison

Hybrid Artificial Bee Colony Algorithm for Parameter Estimation of Proton Exchange Membrane Fuel Cell

An Evaluation Study of Fuel Cell Hybrid Topology for Vehicles

A Comprehensive System-Level Model for Performance Evaluation of Proton Exchange Membrane Fuel Cell System with Dead-Ended Anode Mode

Modeling and Subjective Evaluation Method of Driveability for Fuel Cell Vehicles

Performance evaluation on thermodynamics-economy-environment of PEMFC vehicle power system under dynamic condition

Fuel Cell Electric Vehicle Modeling Using Hybrid/Battery/Fuel Cell Vehicle Modeling Tool (HBFCMT)

Multi-criteria evaluation and optimization of PEM fuel cell degradation system

A Comprehensive Performance Evaluation Method for Fuel Cell Commercial Vehicles

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

PEMFC Hybrid Model Modeling and Steady Simulation

Operating Performance and Energy Flow Modeling for a Hundred-Kilowatt Proton Exchange Membrane Fuel Cell Stack Test System

Modeling And Simulation Of A Modern Pem Fuel Cell System

Multivariate Efficiency Assessment and Optimization of Unitized Regeneration Proton Exchange Membrane Fuel Cell Based CCHP System

Simulation and optimization of hydrogen consumption in a fuel cell/battery hybrid vehicle

Topology Comparison and Sensitivity Analysis of Fuel Cell Hybrid Systems for Electric Vehicles

A new technique for optimising of a PEMFC based CCHP system

A Hierarchical Optimizing Energy Management Strategy for Alleviating Degradation in Fuel Cell Hybrid System

Process Modeling of Fuel Cell Vehicle Power System

Hierarchical Power Allocation Method Based on Online Extremum Seeking Algorithm for Dual-PEMFC/Battery Hybrid Locomotive

Influence of Powertrain Parameters on Vehicle Performance of a Fuel Cell / Battery City Bus