Optimization of Shaping Circuit and Low-Pass Filter in Laser Ranging System

YOU Zheng,YANG Ran,ZHANG Gao-fei,XUE Xu-feng,YE Liang-chen

DOI: https://doi.org/10.3788/ope.20132110.2527

2013-01-01

Optics and Precision Engineering

Abstract:As the phase discrimination error of a phase laser ranging system effects its ranging accuracy,this paper optimizes the designs of a preceding stage(shaping circuit)and a subsequent stage(low-pass filter)in the phase detector.For the shaping circuit,a comparator with hysteresis was designed to avoid the multiple-triggered phenomenon caused by the noise on GND for open loop filters,and stabilizes the output of phase detector.For the low-pass filter,two typical amplifier/filter circuits based on MC4044 and their defects were introduced,a 4th-order low-pass filter was designed by using FilterPro,and its advantages were presented.Experimental results indicate that the multiple-triggered phenomenon is eliminated by using the hysteresis comparator designed,and the rise-time of output square wave falls to 108ns from 1.66μs as compared with that of a traditional opened-loop comparator.Furthermore,the 4th-order filter designed in this paper improves the linearity and sensitivity of the DC output,the linearity(R2)increases from 0.908 3 to 0.999 9,and the convention gain improves by 96.5%as compared with that of the typical designs of amplifier/filter circuits.Moreover,the peak-to-peak value of the interference signal on a Low Pass Filter(LPF)DC output decreases from 50-230mV to 10-20mV,which reduces the phase detection error effectively.