Abstract:For microelectronic industry, Cu-based substrate and epoxy molding compound (EMC) interface is inherently weak and most likely to delaminate, well-known as a major threat for integrated circuits (ICs) reliability. In this paper, hierarchical whisker-like oxide/Cu cone structure was for the first time to be fabricated by combining electroless plating with heat treatment methods to enhance the interface adhesion between Cu-based substrate and EMC. The surface morphology was characterized by scanning electron microscope (SEM). Result shows that the hierarchical whisker-like oxide/Cu cone film is fine, dense and uniform; Single Cu cone structure is about 3-5 μm in height and 1 μm in root diameter; a layer of whisker-like oxide grows perpendicularly to circular surface of Cu cone, with length ranging from tens to hundreds of nanometers. Adhesion strength between the as-prepared substrates and EMC were measured by button shear test. With consideration of oxidation caused by practical processes (e.g. wire bonding), the interface of EMC and porous oxide formed at 260°C for 5 min was taken as standard sample, representative of practical interface. To further study the effect of whisker-like oxide and Cu cone solely on adhesion performance, whisker-like oxide, porous oxide/Cu cone were investigated as well. Button shear test results reveal that interfacial adhesion strength of EMC and whisker-like oxide, porous oxide/Cu cone, hierarchical whisker-like oxide/Cu cone are 85%, 110% and 162% higher than that of standard interface. Moreover, the mechanism for adhesion improvement was discussed by facture surface observation, failure path assumption and force-displacement curve analysis. Results show that interface of EMC and hierarchical whisker-like oxide/Cu cone exhibits brittle/ductile property with about 3-5 μm thick EMC left on the fracture surface, indicating cohesive failure caused by remarkable mechanical interlocking effect. © 2011 Elsevier Ltd. All rights reserved.

IMPROVEMENT OF THE PEELING STRENGTH OF THIN FILMS BY A BIOINSPIRED HIERARCHICAL INTERFACE

Adhesion improvement of Cu-based substrate and epoxy molding compound interface by hierarchical structure preparation

Multiple kinds of peeling processes and instabilities in heterogeneous film peeling

90-degree peeling of elastic thin films from elastic soft substrates: Theoretical solutions and experimental verification

Competing Behavior of Interface Delamination and Wafer Cracking During Peeling Film from Ultra-Thin Wafer

Peeling Mechanics of Film-Substrate System with Mutually Embedded Nanostructures in the Interface

Rate-dependent Peeling Behavior of the Viscoelastic Film-Substrate System

Harnessing strong and asymmetric adhesion by combining film heterogeneity and substrate morphology

Multi-peeling states of elastic film from flexible substrate

Active Control of Surface Integrity in Thin Film Scratching and Finishing

Discretely Supported Dry Adhesive Film Inspired by Biological Bending Behavior for Enhanced Performance on A Rough Surface

Curvature Induced Hierarchical Wrinkling Patterns in Soft Bilayers

A General Solution to the Maximum Detachment Force in Thin Film Peeling

Interfacial Shear Effect On Herringbone Pattern Of Thin Films On Compliant Substrates

Electro-capillary peeling of thin films

Surface Wrinkling Patterns of Film–Substrate Systems with a Structured Interface

Bioinspired film-terminated ridges for enhancing friction force on lubricated soft surfaces

Toughening and Asymmetry in Peeling of Heterogeneous Adhesives

Toughening of hydrogel adhering interface based on soft/hard heterogeneous structures

Thermally Assisted Peeling of an Elastic Strip in Adhesion with a Substrate Via Molecular Bonds