Effect of the Compact Ti Layer on the Efficiency of Dye-Sensitized Solar Cells Assembled Using Stainless Steel Sheets

Lijian Meng,Mingxing Wu,Yongmei Wang,Wei Guo,Chunyu Ma,Tingli Ma,Rui Silva
DOI: https://doi.org/10.1016/j.apsusc.2012.12.157
IF: 6.7
2013-01-01
Applied Surface Science
Abstract:Titanium films have been deposited on stainless steel metal sheets using dc magnetron sputtering technique at different substrate temperatures. The structure of the titanium films strongly depend on the substrate temperature. The titanium film deposited at the substrate temperature lower than 300 degrees C has a loose flat sheet grains structure and the titanium film prepared at the substrate temperature higher than 500 degrees C has a dense nubby grains structure. The DSSC assembled using stainless steel sheet coated with titanium film deposited at high substrate temperature has a low charge transfer resistance in the TiO2/Ti interface and results in a high conversion efficiency. The DSSC assembled using stainless steel sheet coated with titanium film deposited at temperature higher than 500 degrees C has higher conversion efficiency than that assembled using titanium metal sheet as the substrate. The maximum conversion efficiency, 2.26% is obtained for DSSC assembled using stainless steel sheet coated with titanium film deposited at 700 degrees C substrate temperature, which is about 70% of the conversion efficiency of the FTO reference cell used in this study. (C) 2013 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?