Abstract:Fluid flow characteristics and particle motion behavior of an impinging stream reactor with dynamic inlet flow (both inlet velocity patterns exhibit step variation) are investigated and discussed with the computational fluid dynamics–discrete element method (CFD–DEM). The effect of T (variation period of the dynamic inlet flow) and ∆u (inlet velocity difference) on the motion characteristics of single and multiple particles, as well as the mean particle residence time, are studied and discussed. The research results indicate that, compared with the traditional impinging stream reactor (both inlet velocities are equal and constant) with equal mean inlet velocity (um) within one period, the impinging surface is instantaneously moving and the flow regime is varied with time in the impinging stream reactor with dynamic inlet flow. The impinging stream reactor with dynamic inlet flow provides higher cost performance over the traditional impinging stream reactor, under equal um, in terms of single-particle residence time. Moreover, three new particle motion modes exist in multi-particle motions of the impinging stream reactor with dynamic inlet flow; particles are accelerated by the original or reverse fluid and perform oscillatory motion at least once after an interparticle collision. Whether it is a single particle or multi-particles, the mean particle residence time reaches a maximum value when T/2 is approximately equal to the first particle acceleration time, since the maximum axial kinetic energy increases in every oscillatory motion compared with traditional impinging stream, and the number of oscillatory motions is increasing. The mean residence time of a particle in the impinging stream reactor with a dynamic inlet flow increases with increasing ∆u, since the dynamic inlet conditions and increasing ∆u can continuously supply more energy to particles and thus cause more particles to enter one of the three new modes of particle motion.

Dsmc Prediction of Particle Behavior in Gas-Particle Two-Phase Impinging Streams

Study on hybrid DSMC/EPSM method for chemical reacting gas flow

The Hypersonic Chemical Reaction Flow of Flat-Nosed Cylinder with Hybrid DSMC/EPSM Method

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Distribution of Particle Resident Time in a Combined Coaxial Gas–solid Two-Phase Impinging Stream

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Direct Numerical Simulation of Particle Dispersion in a Turbulent Jet Considering Inter-Particle Collisions

Numerical Study of Inter-Particle Collision in Dilute Two-Phase Jet

Numerical Simulations of a Gas–Solid Two-Phase Impinging Stream Reactor with Dynamic Inlet Flow

Direct Numerical Simulation of a Three-Dimensional Particle Laden Plane Mixing Layer Considering Inter-Particle Collisions

Direct numerical simulation of atomization by jet impact using moving particle semi-implicit method with GPU acceleration

A Euler-Euler Hydrodynamic Modelling and Simulation of Dense Particle Flow in a Small-Scale Fluidized Bed

Assessment of Mesoscopic Particle-Based Methods in Microfluidic Geometries

DPD simulation of multiphase flow at small scales

Direct simulation of interfacial flows for multi-phase and multi-component mixtures using the particle method

Numerical simulation on inter-particle collision in dense gas-solid of circulating bed

Direct Numerical Simulation of Flashing Liquid Injection by Moving Particle Semi-Implicit Method

Numerical Prediction on Deposition of Micro-Particulate Matter in Turbulent Channel Flows

Hydrodynamic Modeling of Turbulence Modulation by Particles in Swirling Gas-Particle Two-Phase Flow

Numerical Study of Particle–particle Collision in Swirling Jets: A DEM–DNS Coupling Simulation

Direct numerical simulation of the three-dimensional plane mixing layer considering inter-particle collision