Investigation on Fluid Added Mass Effect in the Modal Response of a Pump-Turbine Runner

L. Y. He,Y. He,Y. Y. Luo,Z. W. Wang

DOI: https://doi.org/10.1088/1757-899x/52/2/022038

2013-01-01

IOP Conference Series Materials Science and Engineering

Abstract:With the improvement of technology and manufacturing level of hydraulic turbine, there is a trend to increase the power concentration of the units. As a consequence, heads, fluid velocities and rotational speeds are higher which lead to larger hydraulic excitation forces on the structures. Accordingly, vibration and high stress levels will arise, which may cause fatigue damage. Therefore, how to predict the natural frequencies and mode shapes of the runner during the design stage is of paramount importance. In this paper, numerical simulation to analyze the influence of the surrounding water in a pump-turbine runner modal has been carried out by using finite element method. The modal behavior of the runner in air and in water has been calculated. In addition, the added mass effect by comparing the natural frequencies and mode shapes in both cases has been determined. The results show that, due to the added mass effect of the surrounding water, natural frequencies are considerably reduced. The frequency reduction ratio (FRR) varies in a range of 0.06 similar to 0.43, depending on the mode shapes. Vibration amplitude and complexity of modes are the two main factors that affect the reduction ratio of runner natural frequencies. For the FRR of in-phase (IP) mode shapes, the vibration amplitude of each mode is considered to be the dominant reason. It is clear that the FRR decreases as the nodal diameter (ND) increases (except for 0ND). While for counter-phase (CP) mode shapes, with the frequency increases, the runner modes will become more and more complex, as a result of which, the FRR increases.