Abstract:Atomic clocks provide a reproducible basis for our understanding of time and frequency. Recent demonstrations of compact optical clocks, employing thermal atomic beams, have achieved short-term fractional frequency instabilities in the $10^{-16}$, competitive with the best international frequency standards available. However, a serious challenge inherent in compact clocks is the necessarily smaller optical beams, which results in rapid variation in interrogating wavefronts. This can cause inhomogeneous excitation of the thermal beam leading to long term drifts in the output frequency. Here we develop a model for Ramsey-Bord\'e interferometery using optical fields with curved wavefronts and simulate the $^{40}$Ca beam clock experiment described in [Olson et al., Phys. Rev. Lett. 123, 073202 (2019)]. Olson et al.'s results had shown surprising and unexplained behaviour in the response of the atoms in the interrogation. Our model predicts signals consistent with experimental data and can account for the significant sensitivity to laser geometry that was reported. We find the signal-to-noise ratio is maximised when the laser is uncollimated at the interrogation zones to minimise inhomogeneity, and also identify an optimal waist size determined by both laser inhomogeneity and the velocity distribution of the atomic beam. We investigate the shifts and stability of the clock frequency, showing that the Gouy phase is the primary source of frequency variations arising from laser geometry.

Microwave Cavity Design for an Optically-Pumped Rubidium Atomic Beam Clock

Design and test of the microwave cavity in an optically-pumped Rubidium beam frequency standard

Compact Vapor Cell Cesium Clock Based on Continuous Wave Optical Pumping

Rubidium-beam Microwave Clock Pumped by Distributed Feedback Diode Lasers

A new scheme of compact cold atom clock based on diffuse laser cooling in a cylindrical cavity

Digital Square-Wave Frequency Modulated Microwave Sources For A Miniature Optically Pumped Cesium Beam Clock

An additive-manufactured microwave cavity for a compact cold-atom clock

Towards a Raman-Ramsey Clock Based on a Cold Cesium Beam

A chip-scale atomic beam clock

A Caesium Atomic Beam Microwave Clock Detected by Distributed Feedback Laser Diodes

Beam optics analysis on magnetic-state-selected atomic clocks with optical detection

Wavefront Curvature in Optical Atomic Beam Clocks

A Linewidth Locking Method to Control the Microwave Power in Optically Pumped Cesium-Beam Clocks

Novel Loop-electrode Microwave Cavity for Gas Cell Rubidium Frequency Standard

Faraday Laser with Cavity Mode Locked for Optical Pumped Rubidium Atomic Clock

Microwave Atomic Clock in the Optical Lattice with Specific Frequency

Design of Optically Pumped Cesium Beam Tube with Hexapole Magnetic System for Longer Lifetime and Better SNR

Improved Rubidium Atomic Beam Clock Based on Lamp-Pumping and Fluorescence-Detection Scheme

Proposal Of Rubidium Atomic Beam Clock Based On Lamp Pumped And Fluorescence Detection

A New Magnetic State Selection Method in High-Performance Optically Detected Compact Cesium Beam Clocks.

Faraday laser pumped cesium beam clock