Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Discrete Element Simulation of Wet Particles Flow Behavior in Riser

Discrete element simulation of gas-solids flow behavior in riser

Eulerian-Lagrangian Simulation of Distinct Clustering Phenomena and Rtds in Riser and Downer

Steady-state Simulation of Core-Annulus Flow in a Circulating Fluidized Bed (CFB) Riser

CFD-DEM Simulation of Clustering Phenomena in Riser and Downer

Numerical Simulation of Fluid Dynamics of a Riser: Influence of Particle Rotation

Clustering in Gas-Fluidized Riser Flows of Flexible Fibers

Computational Fluid Dynamics of Riser Using Kinetic Theory of Rough Spheres

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Computational Fluid Dynamics–Discrete Element Method (CFD-DEM) Study of Mass-Transfer Mechanisms in Riser Flow

Eulerian-Lagrangian simulation of hydrodynamics of gas-solid flows in downer

Numerical Simulation of Flow Behavior of Liquid and Particles in Liquid–solid Risers with Multi Scale Interfacial Drag Method

Micro Flow Behaviors of Particles in Riser

CFD–DEM Simulation of Pneumatic Conveying in a Horizontal Channel

Numerical analysis on the transport properties and residence time distribution of ribbon biomass particles in a riser reactor based on CFD-DEM approach

Large-eddy Simulation of the Flow Behaviors of Gas and Particles in a Riser

Flow Behavior of Clusters in a Riser Simulated by Direct Simulation Monte Carlo Method

Prediction of Flow Behavior of Micro-Particles in Risers in the Presence of Van Der Waals Forces

Computational Characterisation of Intermittent Hydrodynamic Behaviours in a Riser with Geldart A Particles

HETEROGENEOUS FLOW STRUCTURE IN GAS-SOLID RISERS : CONTINUOUS MODELING

Discrete Element Simulation of Particle Flow in Arbitrarily Complex Geometries