Abstract:A new nondestructive pressure-measurement method that can avoid potential safety problems caused by applying traditional pressure-measurement methods in vessels is presented. This method utilizes ultrasonic Rayleigh waves and critically refracted longitudinal waves ( L CR waves). The change in pressure induces a change in the stresses in the vessel's wall. According to the acoustoelastic principle, variations in stress affect the wave velocity. Meanwhile, the velocity of ultrasonic waves can also be affected by the change in temperature. Considering the effect of the pressure and temperature of the vessel on both the wave velocity and propagation distance of the ultrasonic waves, the relationship between ultrasonic transit time delay and both the pressure and temperature change is established. Furthermore, a modified model of pressure measurement is deduced. With this model, a reference method for temperature compensation, without temperature measurement, is presented. The reference method utilizes Rayleigh waves and L CR waves. These two kinds of ultrasonic waves travel along the axial direction of the vessel's wall, bearing the same changes in pressure and temperature. The relationship between the reference transit time delay between two ultrasonic transducers and the pressure is established through theoretical analysis and calibration tests on an air vessel. To reduce the error caused by the unevenness of temperature distribution, which might occur in the vessel's and the transducer's material, a new kind of transducer is used in the experiment, which has two piezoelectric elements and can be used for the Rayleigh and L CR waves. A pair of such transducers is mounted along the axial direction of the air vessel. The penetration area of the Rayleigh wave is almost the same as that of the L CR wave with the use of the new transducers. Comparison tests between the new transducers and the custom-used transducers show that the new transducers have better repeatability. Finally, using the air vessel as a specimen, experimental results show that the reference method is effective and that the pressure values calculated using the reference method are close to the manometer-measured values.

Delay Pressure Detection Method to Eliminate Pump Pressure Interference on the Downhole Mud Pressure Signals

Adaptive Dual-Sensor Noise Cancellation Method for Continuous Wave Mud Pulse Telemetry

Study on Dynamic Pressure Detection Method for Flow Field Based on PVDF Film

Noise Removal for the Steady-State Pressure Measurements Based on Domain Knowledge of Water Distribution Systems

Downhole mud loss transient simulation and detection with downhole dual measurement points

Time-Series-Based Leakage Detection Using Multiple Pressure Sensors in Water Distribution Systems.

A detection and identification method of minor pressure pulse at high static pressure for pressure pulse bidirectional communication

Noise Cancellation for Continuous Wave Mud Pulse Telemetry Based on Empirical Mode Decomposition and Particle Swarm Optimization

Pressure Sensor Based on the Time-Interval Between Neighboring Longitudinal Waves

Study on Wavelet Filtering Method of Pressure in Concrete Pump Transport Pipe

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and L-Cr Waves

Investigation of the Pressure Probe Properties As the Sensor in the Vortex Flowmeter

A New Nondestructive Technique for Measuring Pressure in Vessels by Surface Waves

Pressure Pulse Wave Attenuation Model Coupling Waveform Distortion and Viscous Dissipation for Blockage Detection in Pipeline

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and <formula> <tex>$l_{\rm CR}$</tex> </formula> Waves

Pressure Measurement Based on Multi-Waves Fusion Algorithm

Research on Detection of Vortex Flowmeter Signal with Differential Pressure

A Non-Intrusive Pressure Sensor by Detecting Multiple Longitudinal Waves

Model Analysis and System Parameters Investigation for Transient Wave in a Pump–Pipe–Valve System

A Differential Pressure Sensor Coupled with Conductance Sensors to Evaluate Pressure Drop Prediction Models of Gas-Water Two-Phase Flow in a Vertical Small Pipe

A new method for nondestructively measuring pressure based on the Rayleigh wave