Large forging die manufactured with dual hardfacing metal layer on cast steel matrix

Shun Lu,Jie Zhou,Mengyao Li,Yongfeng Ding

DOI: https://doi.org/10.13251/j.issn.0254-6051.2013.10.018

2013-01-01

Abstract:The die manufacturing method , which takes special cast steel as the die base and dual hardfacing layer ( the transition layer and strengthening layer ) are welded on the working area of the cast steel , was proposed to design and manufacture the large forging die .The dual hardfacing metal layer welding is performed , and then the microstructure of samples is analyzed by optical microscope and SEM .The hardness, impact properties and impact fracture of welding and substrate are measured .The results show that in the transition layer there is mainly fine acicular ferrite which enforces the toughness and strength of die , and prevent increases the crack .The strengthening layer is combined with substrate for the transition layer exists .In this method, the mechanical properties , hardness is gradually slowly , and meet the operating requirements for forging die .The service life of the forging die on the 40 MN hot die forging press is 7166 , and increase 50%, the cost decrease 20%compared with the traditional die manufacturing method .