Abstract:It is a challenge to polish the interior surface of a small bent pipe with complex structures and sizes less than 0.5 mm. This is because of the fact that traditional polishing methods could destroy, block, or break the small complex structures. For a small bent pipe made of aluminum alloy produced using additive manufacturing, the defects, such as adhered powders and spatters, are easy to jam the pipe without polishing, possibly resulting in catastrophic failure for aerospace applications. To overcome this challenge, a novel water jet polisher was developed using soft polymethyl methacrylate (PMMA) abrasives. After polishing a specific area, the adhered powders on the interior surface were reduced from over 140 to 2, 3, and 6 by the soft abrasives with mesh sizes of 200, 400, and 600, respectively. The surface roughness Sa was decreased from 3.41 to 0.92 μm after polishing using PMMA abrasives with a mesh size of 200. In comparison, silica abrasives were also employed to polish the small bent pipes, leading to the bent part of pipes breaking. However, this kind of failure was absent when using soft abrasives. Computational fluid dynamics calculations elucidate that a peak erosion rate of silica abrasives for a bent pipe with a turn angle of 30° is 2.18 kg/(m2·s), which is 17 times that of soft abrasives. This is why the small bent pipe was broken using silica abrasives, whereas it remained intact when polished with soft abrasives. In addition, water jet polishing has a lower erosion rate, a relatively smooth erosion curve, and less erosion energy, leaving the bent parts intact. The developed soft abrasive water jet polisher and the findings of this study suggest new possibilities for cleaning the adhered powders and spatters and polishing the interior surface of small bent pipes with complex structures.

An Experimental Research on Abrasive Water Jet Polishing of the Hard Brittle Ceramics

Experimental Reasearch on Grinding Surface Waviness of Engineering Ceramics

Study on Polishing Technology for Hard-Brittle Materials by a Micro Abrasive Water Jet

Study on Machining System of Precision Micro Abrasive Water Jet and Polish Experiment

An Experimental Study on Radial-Mode Abrasive Waterjet Turning of Alumina Ceramics

Material removal mechanisms of ceramics turned by abrasive waterjet (AWJ) using a novel approach

Theoretical and Experimental Investigation on Inclined Ultrasonic Elliptical Vibration Cutting of Alumina Ceramics

Experimental Investigation of Aluminum Nitride Ceramics Based on Compliant Finishing Process

Material Removal Analysis in the Radial-Mode Abrasive Waterjet Turning of Ceramic Materials

Experimental Investigation into the Effect of Abrasive Process Parameters on the Cutting Performance for Abrasive Waterjet Technology: a Case Study

Optimization of Machining Parameters in the Abrasive Waterjet Turning of Alumina Ceramic Based on the Response Surface Methodology

Study on Pre-Mixed Micro Abrasive Water Jet Machining System

The Cutting Performance in Multipass Abrasive Waterjet Machining of Industrial Ceramics

Research progress of laser polishing of engineering ceramic

Modeling and optimization of operating parameters for abrasive waterjet turning alumina ceramics using response surface methodology combined with Box–Behnken design

Study on the Effect of Standoff Distance on Processing Performance of Alumina Ceramics in Two Modes of Abrasive Waterjet Turning Patterns

Numerical and experimental investigation on the material removal profile during polishing of inner surfaces using an abrasive rotating jet

Fem Analysis on the Abrasive Erosion Process in Ultrasonic-Assisted Abrasive Waterjet Machining

Study on Jet Formation and Modeling for High Pressure Abrasive Water-Jet

Development of a Novel Water Jet Polisher Using Soft Abrasives for Small Complex-Structure Heat Pipes of Aluminum Alloy Produced Using Additive Manufacturing

Abrasive Jet Polishing Utilizing the Synergistic Effect of Ultrasonic Pulse-Cavitation and Process Optimization Research