Abstract:This article proposes an approximate prediction method for slamming loads in parametric rolling condition for large container ships and the method has been validated through model experiments. Up to now, there have been some studies focused on two-dimensional asymmetric slamming analysis. Nevertheless, slamming load prediction in parametric rolling condition should consider not only heave and pitch motions, but also large amplitude roll motion which is usually neglected in analysis. For this purpose, a 6-DOF weakly nonlinear time domain model is adopted to predict the ship motions including parametric roll motion. The consequent roll motions obtained by the proposed model are incorporated in the calculation of impact angle and relative vertical velocity between ship section on the bow flare and wave surface, according to an asymmetric water entry assumption. Slamming impact loads and occurrence probability of slamming are analyzed by the Wagner model. To validate the numerical method, the segmented model experiment of a 10000 TEU container ship was executed and the slamming impact pressures and bending moments were measured for the wave condition and ship forward speed. The calculated pressures are compared with experiments. Based on numerical simulations, the maximum flare slamming pressures and slamming occurrence probability in different speed and wave conditions are investigated. The results indicate that flare slamming pressure is smaller than bottom slamming, but possessing longer lasting time and the occurrence of flare slamming is associated with the cycles of parametric rolling motions. Furthermore, the relationship between slamming pressure and 3-DOF motions namely roll, pitch and heave in the simultaneous simulation is given and the mechanism of flare slamming phenomena in parametric rolling condition is elaborated.

Effect of Calculation Methods of Roll Moment of Inertia on Sensitivity Prediction of Parametric Rolling for Container Ships

Research on the parametric rolling of the KCS container ship

Influence of wind load on predicting parametric rolling of real ship

Numerical Predictions of Head Sea Parametric Roll and Its Rudder Stabilization Based on the Unified Model

Parametric Roll Prediction of the KCS Containership in Head Waves with Emphasis on the Roll Damping and Nonlinear Restoring Moment

NUMERICAL MODELLING AND STUDY OF PARAMETRIC ROLLING FOR C11 CONTAINERSHIP IN REGULAR HEAD SEAS USING CONSISTENT STRIP THEORY

A Study of Hybrid Prediction Method for Ship Parametric Rolling

A Study On Applicability Of Cfd Approach For Predicting Ship Parametric Rolling

Numerical Study on Ship Parametric Roll in Head Waves

Comprehensive Calculation and Safety Assessment of Parametric Roll of Very Large Container Ship

Weakly Nonlinear Ship Motion Calculation and Parametric Rolling Simulation Based on the 3DTGF-HOBEM Method

Numerical Prediction And Experimental Validation Of Slamming Load For Large Container Ship Undergoing Parametric Rolling Motion

Approximation Method for Flare Slamming Analysis of Large Container Ships in Parametric Rolling Conditions

Stochastic assessment of acceleration probability density function for parametric rolling using the moment method

Research on Parametric Roll of the Polar Environmental Transport Ship Based on Time-Domain Rankine Panel Method

Time Domain Simulations of Ship Maneuvering and Roll Motion in Regular Waves Based on a Hybrid Method

Stochastic Assessment of Acceleration Probability Density Function for Parametric Rolling Using Moment Method

Sensitivity Analysis of Parametric Roll Resonance in for Ships Irregular Waves

Numerical Analysis of Viscous Effect on Ship Rolling Motions Based on CFD

Critical Wave Groups Versus Direct Monte-Carlo Simulations for Typical Stability Failure Modes of a Container Ship

Damping Prediction of a Rolling Ship with Bilge Keel in Viscous Flow Based on Numerical Simulation