Abstract:Interleaved power factor correction (PFC) is widely used circuit topology due to good efficiency and power density for single-switch boost PFC. As the differential mode (DM) electromagnetic interference (EMI) noise magnitude depends upon the input current ripple, this research details a comprehensive study of DM EMI filter design for interleaved boost PFC with the aim of minimizing the component size. It is also demonstrated that the different numbers of interleaved stages and switching frequency influence the filter attenuation requirement and, thus, the EMI filter size. First, an analytical model is derived on the basis of the Norton equivalent circuit model for the differential mode noises of interleaved boost PFC within the frequency range of 9–500 kHz. The derived model can help identify the proper phase shifting among the interleaved boost converters in order to minimize the considered differential mode noises at the filter design frequency. So, a novel phase-shift method is developed to get a minimized attenuation required by a filter in Band B. Further, a volume optimization of the required DM filter was introduced based on the calculated filter attenuation and volumetric component parameters. Based on the obtained results, unconventional and conventional phase shifts have demonstrated a good performance in decreasing the EMI filter volume in Band B and Band A, respectively. A 2-kW interleaved PFC case study is presented to verify the theoretical analyses and the impact of phase-shifting on EMI filter size.

EMI filter optimization by adjusting common mode noise impedance of a balanced boost converter

A Method for Adjusting Common Mode Noise Impedance and Optimizing EMI Filters

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

EMI Filter Design Based on High-Frequency Modeling of Common-mode Chokes

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A Novel Common-Mode Conducted EMI Filter for Boost PFC Converter

PFC converter with novel integration of both EMI filter and Boost inductors

Integration of Both EMI Filter and Boost Inductor for 1-Kw PFC Converter

Full Electromagnetic Integration of Impedance-Balanced EMI Filters for Single-Phase Power Converters

Alleviation of Electromagnetic Interference Noise Using a Resonant Shunt for Balanced Converters

Integrated EMI filter design with flexible PCB structure

Novel boost PFC with low common mode EMI: modeling and design

Impedance-Balancing-based Modulation Strategy for Common-Mode Noise Elimination of CHB Converter

A Novel Hybrid Common-Mode EMI Filter With Active Impedance Multiplication

A PFC Converter With Novel Integration of Both the EMI Filter and Boost Inductor

EMI Filter Design of SMPS Based on Integrated Choke

Principles and design on integrated EMI filters

Design and Experiment Research of Integrated EMI Filter Based on Flexible Multi-Layer Foils

Differential Mode Noise Estimation and Filter Design for Interleaved Boost Power Factor Correction Converters

Study on the EMI filters to EFT/B tests in power converters

Design of A Low Emi Boost Converter Using Bi-Frequency Pfm Control Mode