Abstract:Abstract Degradation of electronic equipment is typically accompanied by a deviation in their electrical parameters from their design values. When the function of the electronic equipment fails, parametric faults of the electrical parameters will ultimately occur. Such electrical parameters can characterize the state of health can be defined as health parameters. For complex electronic equipment such as hardware circuits of Nuclear power plant DCS cards, the use of health parameters for fault diagnostic has been widely used, but there is no mature method for sub-health diagnostic. To address this problem, an electronic equipment health assessment method was developed using a technology based on the combination of mechanism knowledge and data-driven. The method first uses Physics of Failure approach and hardware circuit logic principle to identify the major failure mechanisms of the circuit, and then determines the key health parameters and their sub-health thresholds on this basis. The time series data under specific test conditions for the key health parameters of the circuits to be assessed is collected and compared with the sub-health thresholds, then the health status assessment results based on mechanism knowledge can be obtained. As well, the data-driven health assessment technology based on Mahalanobis distance is applied to analyze the real-time health parameter data of all samples, and the healthy outlier samples are identified and quantified, and the health status assessment results based on the data-driven technology can be obtained. The results of the two are comprehensively evaluated to finally determine the circuit health status. Practice was carried out on the DCDC chip of a nuclear power DCS analog output module, and the results showed that this method was feasible for engineering.

Sensor failure detection and diagnosis via polynomial chaos theory-part II: Digital realization

Sensor Failure Detection and Diagnosis via Polynomial Chaos Theory—Part I: Theoretical Background

Harmonic and Reactive Current Synchronous Detecting Method Based on DSP

Digital Automatic Voltage Regulator for Synchronous Generator Considering Sensor Failure

ELECTRIC CIRCUIT DESIGN AND TESTING OF INTEGRATED DISTRIBUTED STRUCTRONIC SYSTEMS

Application of Polynomial Chaos Expansion in Electrical Systems Considering Uncertainties: an Overview

Fault Diagnosis and Tolerant Control for Sensors of PWM Rectifier under High Switching Frequency.

A VCB Parameters On-line Condition Monitoring System Based on DSP

Design of Multi-Function Monitoring Integrated Device in Power System

Simultaneous Fault Detection and Control for Uncertain Discrete-Time Stochastic Systems with Limited Communication

Intermittent Sensor Faults Detection Based on Fractional-Order Transient Chaotic System

Analysis and Design of Data Acquisition System Based on DSP for Permanent Magnet Intelligent Circuit Breaker

An Efficient Fdir Strategy on Nonlinear Processes of Self-Validating Multifunctional Sensors

Research on a Circuit Health Assessment Technology Combining Mechanism Knowledge and Data Driven Technology

A Novel Method of Fault Diagnosis Based on Synchronized Phasor Measuring and Flow Fingerprint Identification Technology

Fault Isolation in Hybrid Systems Combining Model Based Diagnosis and Signal Processing

Implementation of an On-line Diagnosis Algorithm of PMSM Inter-turn Short Circuit Based on Search Coil and FPGA

Stochastic Programming-Based Fault Diagnosis in Power Systems under Imperfect and Incomplete Information

Sensor fault detection based on fractional-order chaotic system under strong noise and disturbance.

Analytical model for power system fault diagnosis integrated with information theory

Sensor Fault Diagnosis for Linear Time-Delay Systems