Effects of BaM interfacial layer on the c-axis orientation of BaM thin films deposited on SiO2/Si substrates

Zhiyong Xu,Zhongwen Lan,Ke Sun,Zhong Yu,Rongdi Guo,Feiming Bai

DOI: https://doi.org/10.1109/TMAG.2013.2245306

IF: 1.848

2013-01-01

IEEE Transactions on Magnetics

Abstract:M-type barium ferrite (BaM) thin films with two different structures (single layered and double layered) were deposited on thermally oxidized silicon (SiO2 /Si) substrates by radio frequency (RF) magnetron sputtering. The changes in surface morphologies, crystallographic and magnetic properties of the films corresponding to different structures and substrate temperatures (Ts) were investigated in detail. In the single layered films deposited directly on SiO2/Si substrates at Ts= 300°C and Ts = 500° C respectively, most of the grains are acicular type. XRD data and magnetic properties measurement confirmed that they are both weakly c-axis perpendicularly oriented. However, in the double layered film with first interfacial layer deposited at Ts= 300°C and second layer deposited at Ts= 500°C, good crystallographic characteristics and excellent perpendicular c-axis orientation were obtained. The c -axis dispersion angle (Δ θc) decreased to 0.51°C; the lattice parameters were comparable to those of the bulk BaM; the squareness ratio and coercivity of the out-of-plane increased to 0.85 and 338 kA/m, respectively, for the double layered film. The mechanism for improving perpendicular c-axis orientation with an interfacial BaM layer was attributed to two reasons. One is a relative increase in the nucleation sites for perpendicularly oriented grains over the nucleation sites for in-plane and/or randomly oriented grains, and the other is the release of stress that comes from the interface between BaM thin film and SiO2/Si substrate. © 2013 IEEE.