Biomimetic fabrication of α-Fe 2 O 3 with hierarchical structures as H 2 S Sensor

Wenhong Peng,Chengling Zhu,Shenmin Zhu,Fan Yao,Yao Li,Di Zhang
DOI: https://doi.org/10.1007/s10853-013-7249-1
IF: 4.5
2013-01-01
Journal of Materials Science
Abstract:A facile sol–gel method is developed for the fabrication of α-Fe 2 O 3 with quasi-honeycomb like structures inherited from Papilio paris butterfly wings. The exquisite hierarchical architecture is faithfully maintained in α-Fe 2 O 3 from the skeleton of butterfly wings at the levels from macro to nano-scales. When used as a chemical sensor, the obtained α-Fe 2 O 3 replica (P-α-Fe 2 O 3 ) showed a much higher performance than that of the compared α-Fe 2 O 3 nanoparticles synthesized under the same condition without biotemplate (S-α-Fe 2 O 3 ). The P-α-Fe 2 O 3 -based sensor has a sensitivity of 19.2–50 ppm H 2 S, which is four times more than that of S-α-Fe 2 O 3 , accompanied by a rapid response/recovery time within 1/10 s even at a relatively low working temperature of 180 °C. Compare to the S-α-Fe 2 O 3 , surface area of which cannot be detectable, the high sensing feature of P-α-Fe 2 O 3 would be attributed to the relatively high-specific surface area 24.12 m 2 /g thus fabricated together with the unique 3D-network structures, which provide channel for the diffusion of H 2 S. This strategy is expected to be used in fabrication of other kinds of metal oxide with unique structures for the potential application in gas sensor.
What problem does this paper attempt to address?