Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Hydrothermal Synthesis of Anatase TiO 2 Nanoflowers on a Nanobelt Framework for Photocatalytic Applications

Hydrothermal synthesis and photocatalytic activity of combination of flowerlike TiO2 and activated carbon fibers

One-pot Hydrothermal Synthesis of the Dual-Phase Anatase/tio2-B Nanoparticles with K2Ti6O13 Nanofibers for Enhanced Photocatalysis

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

Effects of Hydrothermal Time on the Morphologies of Rutile TiO2 Hierarchical Nanoarrays and Their Optical and Photocatalytic Properties

Controllable Hydrothermal Synthesis, Optical and Photocatalytic Properties of TiO2 Nanostructures

Titania Nanoflowers with High Photocatalytic Activity

Preparation of Necklace‐Structured TiO2/SnO2 Hybrid Nanofibers and Their Photocatalytic Activity

Construction of Ni-doped Belt-on-belt TiO2 Thin Film to Assist Photodegradation of Rhodamine B in Water

(001)-Exposed TiO2 Microcrystals Decorated with Few-Layer Nanobelts for Enhanced Photocatalytic Activity

A facile synthesis of hierarchical TiO2 for dye adsorption and photocatalysis

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

Fabrication and Photocatalytic Activity of Tio2 Nanofiber Membrane

Self-assembly and Photocatalysis of Mesoporous TiO 2 Nanocrystal Clusters

Templated Synthesis of TiO2 Nanotube Macrostructures and Their Photocatalytic Properties

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Direct Continuous Hydrothermal Synthesis of High Surface Area Nanosized Titania

Photocatalytic activity of TiO 2 nanorods, nanowires and nanoflowers filled with TiO 2 nanoparticles

Alkaline hydrothermal synthesis of homogeneous titania microspheres with urchin-like nanoarchitectures for dye effluent treatments.

Fabrication and Photocatalysis of TiO2 Flower-like Nanostructures

Enhanced photocatalytic performance of porous TiO 2 nanobelts with phase junctions