Abstract:Introduction It has been increasingly difficult to further improve the performance of Si MOSFETs by conventional device scaling down . Therefore, the employment of high mobility channel materials has been considered as one of the most promising solutions to enhance the CMOS devices performance . Ge has been attracting a lot of interest as the channel material for MOSFETs, due to its much higher mobility for both hole and electron compared with those in Si . Although high mobility Ge MOSFETs has been realized by using the thick GeO2/Ge gate stacks , EOT scaling using high-k dielectrics is mandatory to realize high performance Ge MOSFETs. However, it has been found that the mobility is severely decreased in thin EOT high-k/Ge MOSFETs, attributable to the degradation of Ge MOS interface qualities. Thus, the formation of advanced Ge gate stacks with both ultrathin EOT and good interface qualities (low Dit) is the critical issue to obtain superior Ge MOSFETs. In this research, we demonstrate a plasma post oxidation (PPO) technique to oxidize the Ge surface by using oxygen plasma exposure to ALD high-k/Ge structures. Here the high-k layer serves as the oxygen barrier to prevent the growth of unnecessarily thick GeOx interfacial layer (IL), as well as the protection layer to eliminate any damage to the ultrathin GeOx/Ge interface after its formation. As a result, the high-k/GeOx/Ge gate stacks have been formed with sub-nm EOT and low Dit simultaneously. The high mobility Ge MOSFETs have also been realized by using these gate stack structures.

Impact of plasma post oxidation temperature on interface trap density and roughness at GeOx/Ge interfaces

Impact of Plasma Postoxidation Temperature on the Electrical Properties of ${\rm Al}_{2}{\rm O}_{3}/{\rm GeO}_{x}/{\rm Ge}$ pMOSFETs and nMOSFETs

Fabrication and MOS interface properties of ALD AlYO3/GeOx/Ge gate stacks with plasma post oxidation

Impact of Channel Orientation on Electrical Properties of Ge P- and N-Mosfets with 1-Nm Eot Al2o3/Geox/Ge Gate-Stacks Fabricated by Plasma Postoxidation

Al2o3/Geox/Ge Gate Stacks with Low Interface Trap Density Fabricated by Electron Cyclotron Resonance Plasma Postoxidation

Impact of GeOx Interfacial Layer Thickness on Al2O3/Ge MOS Interface Properties

Atomic Layer-By-Layer Oxidation Of Ge (100) And (111) Surfaces By Plasma Post Oxidation Of Al2o3/Ge Structures

1-Nm-thick EOT High Mobility Ge N- and P-Mosfets with Ultrathin GeOx/Ge MOS Interfaces Fabricated by Plasma Post Oxidation

Reduction in Interface Trap Density of Al2O3/SiGe Gate Stack by Electron Cyclotron Resonance Plasma Post-nitridation

Physical mechanism determining Ge p- and n-MOSFETs mobility in high Ns region and mobility improvement by atomically flat GeOx/Ge interfaces

MOS Interface Engineering for High-Mobility Ge CMOS

Physical Origins of High Normal Field Mobility Degradation in Ge P- and N-Mosfets with GeOx/Ge MOS Interfaces Fabricated by Plasma Postoxidation

Ge gate stacks based on Ge oxide interfacial layers and the impact on MOS device properties

Evidence of Layer-by-Layer Oxidation of Ge Surfaces by Plasma Oxidation Through Al2O3

High-quality Germanium Dioxide Thin Films with Low Interface State Density Using a Direct Neutral Beam Oxidation Process

High-Mobility Ge Pmosfet with 1-Nm EOT $\hbox{al}_{2} \hbox{o}_{3}/\hbox{geo}_{x}/\hbox{ge}$ Gate Stack Fabricated by Plasma Post Oxidation

MOS interface control of high mobility channel materials for realizing ultrathin EOT gate stacks

High Mobility Ge CMOS Devices with Ultrathin EOT Gate Stacks Fabricated by Plasma Post Oxidation

Improvement of SiGe MOS interfaces by plasma post-nitridation for SiGe high-k MOS optical modulators

Mos Interface Control Technologies for Iii-V/Ge Channel Mosfets

Low-Temperature Floating Plasma Oxidation of Poly-SiGe