Abstract:The refractive index of silicon-based waveguide materials is highly sensitive to temperature and stress, and the effective refractive index of the waveguide varies with temperature changes. Thus, it is critical to reduce the temperature dependence of Arrayed Waveguide Grating (AWG) devices and to precisely control the center wavelength of AWGs. In this study, the thermoelectric cooler (TEC) was designed and fabricated to control the temperature of the thermal AWG chip, which did not require any material replacement or reprocessing of the AWG chip. Different magnitudes and polarities of voltage are applied to the TEC to regulate its operational state (heating or cooling). A multiphysics simulation model of a thermal AWG device is established and validated through transient and steady-state experiments. This study investigated the influence of different conditions (input voltage, environmental temperature) on the temperature and maximum stress of the AWG chip. A conformal TEC was designed and its performance was compared with that of the square TEC. The energy consumption of the conformal TEC was also tested and analyzed. The results show that in a 25 °C ambient environment, the TEC can control the temperature of the AWG chip in the range of 1.5–78.3 °C, significantly expanding the current operational temperature range of 65.0–85.0 °C when using Positive Temperature Coefficient (PTC) heaters. Under the same conditions, when using the conformal TEC as the temperature control device, the temperature gradient on the AWG chip is reduced by 1.37 °C during cooling and 2.80 °C during heating. The maximum stress value in the core layer is always lower, with a maximum reduction of 3.61 MPa. TEC can set the ideal operating temperature of the AWG chip according to the actual operating environment of the product, which reduces the energy consumption of TEC. A comparison is made between the average power consumption of the conformal TEC and the PTC heater under two operating conditions: a 25 °C constant-temperature environment and a natural environment. The average power consumption can be reduced by up to 97.87 % and 93.02 %, respectively. This study holds significant guidance for solving the temperature dependence problem of AWG devices and the application of thermoelectric coolers in the field of optical communication.

Testing and analysing of 256×256 MOS resistor array for IR scene projector

Ion Write Microthermotics: Programing Thermal Metamaterials at the Microscale

Modeling and Simulation of an Improved Resistive Random Access Memory Array

Electrothermal Simulation of Resistive Random Access Memory(RRAM) Array Using Finite Difference Method

Electrothermal Study on Resistive Random Access Memory (RRAM) Arrays

Ultralarge Pixel Array Photothermal Film based on 3D Self-Suspended Microbridge Structure for Infrared Scene Projection

High‐Performance Infrared Scene Generation Using a Double‐S Microbridge Photothermal Film Emitter With Ultralarge Array

Signal Integrity Analysis for Resistive Random Access Memory Crossbar Array by Compact Model with Consideration of Electro-Thermal Coupling Effects

Electrothermal Investigation on Vertically Aligned Single-Walled Carbon Nanotube Contacted Phase-Change Memory Array for 3-D ICs

Design and Fabrication of A Film Transducer with Composite Microstructures for IR Scene Projection

CMOS-compatible 8×2 thermopile array

Performance Analysis of Microcantilever Arrays for Optical Readout Uncooled Infrared Imaging

Exploring modeling and testing approaches for three-dimensional integrated thermal resistance of chiplets

Thermal-Mechanical Analysis of TSV Array in 2.5D Silicon Interposer

Thermal Resistance Analysis for a High Power 3D Integrated RF Module Based on TSV Interposer

A Novel Transparent Memristor‐Type Infrared Emissivity Modulator for Multispectral Compatible Display

Compensated Resistance Matrix Approach for Readout of the 2-D Resistive Sensor Array for High-Temperature Measurement

A Thermopile Infrared Sensor Array Pixel Monolithically Integrated with an NMOS Switch

Design, fabrication, and characterization of a high-performance CMOS-compatible thermopile infrared detector with self-test function

An experimental investigation and multiphysics simulation of thermoelectric temperature controller for AWG chips

Influence of Thermal Environment on Electrical Properties of Micromachined Polysilicon Thin Film Resistor