Abstract:To address the issue of engine jitter at idle conditions in a specific vehicle model, an initial test of the inertial parameters of the powertrain mounting system was conducted. Utilizing the Adams software, a system model was constructed and subjected to modal analysis. The stiffness of the mounting components was selected as the optimization variable. A deterministic multi-objective optimization was performed on the system’s decoupling rate, natural frequencies, and minimum dynamic reaction force, employing the multi-island genetic algorithm. sensitivity analysis regarding the stiffness of the mounts was conducted based on DOE method. The optimized stiffness values were then re-entered into the Adams software. The results of the deterministic optimization indicated a significant enhancement in the decoupling rate of the powertrain mounting system in the primary direction of concern, a reduction in the natural frequencies, and a decrease to 43.5% of the original scheme in the minimum dynamic force transmitted to the vehicle body. A comparative analysis was conducted on the acceleration amplitude–frequency curves before and after optimization in the Z-direction under idle conditions, and the dynamic reaction force amplitude–frequency curves in three dimensions, both demonstrating a notable attenuation post-optimization. In addition, vibration isolation tests were performed on the powertrain mounting system, comparing the comprehensive isolation rates before and after optimization under idle conditions, with the results fulfilling corporate standards. Finally, based on the stiffness values post-deterministic optimization, robust optimization was conducted employing the 6σ methodology. A robustness analysis of the powertrain energy decoupling rate was performed utilizing the Monte Carlo simulation method, effectively mitigating the tremor issue of the vehicle model under idle conditions.

Parameter Identification of Vehicle Powertrain Mounting System

A General Approach to Tune the Vibration Properties of the Mounting System in the High-Speed and Heavy-Duty Engine

Identification method of vehicle parameters based on genetic algorithms

Parametric Identification Study of an Active Engine Mount: Combination of Finite Element Analysis and Experiment

Modeling and Parameter Identification for A Passive Hydraulic Mount

Non-Linear Modeling and Parameter Identification of Semi-Active Engine Mounts With Air Spring

Parameter Identifications of the Hydraulic Mount

Identification of Physical and Excitation Parameters of Under-Chassis Equipment for Railway Vehicles

A Method for Estimating Mount Isolations of Powertrain Mounting Systems

IMPROVEMENT OF EXPERIMENTAL IDENTIFICATION METHOD WITH TRIFILAR TORSIONAL PENDULUM FOR INERTIA PROPERTIES OF LARGE-SCALE RIGID-BODY

Sensitivity Study and Analysis of the Stiffness of Automobile Engine Mounting System

Design Method for a Powertrain Mounting System to Decrease the Vehicle Key On/off Vibrations

Optimization Design of Powertrain Mounting System Considering Vibration Analysis of Multi-Excitation

Optimization of Idle Vibration Characteristics of Powertrain Mounting System

Test and Modeling of Characteristics of an Engine Rubber Mount

Parameter identification and test study of vane damp for tracked vehicle

Material Parameter Identification Method for Rubber Mount Constitutive Equation

Inertia parameters identification of motor assembly for electric vehicles based on modal test method

IDENTIFICATION OF SYSTEM PHYSICAL PARAMETERS FOR VEHICLE SYSTEMS WITH NONLINEAR COMPONENTS

Parameter Identification of Semi-active Engine Mount Based on Multi-field Coupling Modeling

Modeling and analysis of the vibration characteristics of a new type of in-arm hydropneumatic suspension of a tracked vehicle