Abstract:Vehicle active safety systems can benefit significantly from a priori knowledge of the road conditions. This paper proposes a real-time tyre–road friction estimation algorithm based on an unscented Kalman filter and mean-square-error-weighted fusion, using measurements related to the electric vehicle and in-wheel motors. Because the modules are mutually independent, the dimensionality of the matrix used in the filtering process can be reduced to shorten the computational period. The approach can also work more effectively in various conditions than those techniques which focus on a specific direction of the vehicle dynamics. First, a modified Dugoff et al. tyre model is considered to express the non-linear characteristics of the tyres. Then, to observe the longitudinal tyre forces and the lateral tyre forces, a parameter identification technique that utilizes the information from an inertial sensor and a gyroscope is introduced. An unscented Kalman filter rather than the traditional linear filter is adopted to obtain higher accuracy in the saturation region. After the relationship between the mean square error and the side-slip angle or the slip ratio is taken into account, the final identified value is set by combining the results from the longitudinal unscented Kalman filter and the lateral unscented Kalman filter in order to improve the accuracy and the robustness further. Experiments conducted on both a dry road and a slippery road verify that the method based on an unscented Kalman filter can identify different tyre–road friction levels.

Real-Time Estimation of Vehicle Mass and Road Grade Based on Multi-Sensor Data Fusion

Mass estimation method for intelligent vehicles based on fusion of machine learning and vehicle dynamic model

Longitudinal Vehicle Speed Estimation for Four-Wheel-Independently-Actuated Electric Vehicles Based on Multi-Sensor Fusion

Vehicle Mass and Road Grade Estimation Based on Extended Kalman Filter

Vehicle mass estimation based on high-frequency-information extraction ?

A Hybrid Algorithm Combining EKF and RLS in Synchronous Estimation of Road Grade and Vehicle׳ Mass for a Hybrid Electric Bus

Joint Estimation of Driving State and Road Adhesion Coefficient for Distributed Drive Electric Vehicle

Adaptive estimation of road slope and vehicle mass of fuel cell vehicle

Cascaded Motion Estimation for Intelligent Vehicles in GNSS-Denied Scenes

Vehicle State Estimation Based on V2 I System

Two-layer structure based adaptive estimation for vehicle mass and road slope under longitudinal motion

Fusion of Computer Vision and Piezoelectric Tactility Approach to Measuring Moving Vehicle Loads

Mass and Slope Estimation of Electric Vehicles Equipped with AMT Based on Recursive Least Square Method with Multiple Multiple Forgetting Factors

Vehicular DR system based on multi-sensor fusion

Real-Time Center of Gravity Estimation for Intelligent Connected Vehicle Based on HEKF-EKF

Combined Estimation of Vehicle Body State and Sprung Mass Based on Electronically Controlled Air Suspension System

Speed Estimation for All-wheel Drive Vehicles Based on Multi-information Fusion

Road Slope Aided Vehicle Position Estimation System Based on Sensor Fusion of GPS and Automotive Onboard Sensors

Real-time identification of the tyre–road friction coefficient using an unscented Kalman filter and mean-square-error-weighted fusion

Real-Time Estimation Of Vehicle'S Lateral Dynamics At Inclined Road Employing Extended Kalman Filter

A joint dynamic estimation algorithm of vehicle mass and road slope considering braking and turning