Abstract:The breeder blanket and divertor are crucial plasma facing components in a fusion reactor. The helium cooled blanket and divertor concepts have exhibited the best potential to come up to the highest safety requirements and therefore been chosen for the development object. As a result of high heat flux radiated from the plasma in the fusion reactor and high power density nuclear heat deposited by high-energy neutrons, the cooling of the first wall (FW) and the discharge of nuclear heat have become one of the major technical challenges. To demonstrate and verify the helium-cooled technology and tools of China test blanket module, and explore the feasibility and key technology of thermal hydraulics process of helium-cooled divertor, we have creatively adopted the "filling-evacuating" approach to design and fabricate the high-pressure helium-cooled loop (HPHCL), in which a mock-up of reduced-scale helium-cooled blanket module is designed and manufactured as a test section. Based on different experimental cases, the operating pressures of helium at mockup range from 3 to 10 MPa and the maximum mass flow rate can reach up to 0.21 kg/s. In this paper, the design scheme of the HPHCL is presented, and the key issues of engineering manufacture and the test cases are calculated and analyzed. The helium gas flow and the heat transfer are calculated according to the test working conditions of the referenced International Thermonuclear Experimental Reactor TBM's FW surface heat flux, using ANSYS fluid dynamics software FLUENT. The results will provide support for the follow-up fabrication of test system and implementation of the tests.

Theoretic Analysis on Separation Efficiency of Wire Mesh Mist Eliminator of High-Temperature Gas-Cooled Reactor Helium Purification and Auxiliary System

Experimental design on performance improvement of the helium purification system of HTR 10

High temperature gas cooled reactor tritiated waste water optimizing collection system

DESIGN OF THE GAS SAMPLING AND ANALYZING SYSTEM OF HTR-PM

Experimental Study on Performance Improvement of HTR-10 Helium Purification System

Engineering Design , Analysis and Testing of Helium Circulator used in HTR-PM

Experimental Verification on Design Model of the Passive Residual Heat Removal System of MHTGR

Development and Primary Verification of A Transient Analysis Software for High Temperature Gas-Cooled Reactor Helium Turbine Power System

Design and Analysis of “Filling-Evacuating” High-Pressure Helium-Cooled Loop

Preliminary Study on Application of Pd Composite Membrane in Helium Purification System of High-Temperature Gas-Cooled Reactor

Design Modification and Analysis of Helium Purification System for Gas-Cooled Reactors

Experimental Study on the Residual Heat Removal System in HTR-10

Loss Calculation and Thermal Analysis of Axial AMB in HTR-PM Helium Circulator

A Study of the Type Selection of Mist Eliminators with the Help of a ΔP-v-dcr Method

Analysis of the integral zeolite molecular sieve process for helium CPS application

Purification of helium gas for the helium test loop

Research on Dynamics and Experiments about Auxiliary Bearings for the Helium Circulator of the 10MW High Temperature Gas-Cooled Reactor

Three-dimensional modeling and thermal hydraulic analysis of high temperature gas-cooled reactor core

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Helium Sampling and Analyzing System of 10MW High Temperature Gas-Cooled Reactor

Design Optimization of Gas Separator in High Temperature Gas Cooled Reactor through Numerical Simulation Method