Abstract:<p>Printed circuit heat exchanger (PCHE) is an alternative competitor to be employed in the Liquid Natural Gas (LNG) regasification as vaporizers to meet the increasing demand for the clean energy in the economic development. Different models have been proposed so far for the PCHE, where the majority of them are simplified to a single channel to reduce the computational cost and time. Conventional methods have remarkable challenges, including high computational expense and limitations in engineering applications. In order to resolve these shortcomings, an innovative analysis and design method is proposed in the present study. In the present study, an innovative analysis and design method is proposed, which is based on the thermal network method. The proposed method benefits from both numerical and analytical approaches. It obtains the overall thermal-hydraulic performance of both cold and hot sides and captures the sharp variations of the thermodynamic properties of the supercritical nitrogen. The cross-flow PCHE is divided into a set of typical layers. Moreover, the typical layer is assumed to consist of a set of units, which include cold and hot channels and walls. These units are managed by a code that couples the thermal-hydraulic performance by both hot and cold fluid beginning from the given inlet conditions. Considering the flammable and explosive properties of Natural Gas (NG), liquid nitrogen is selected as the cold fluid. Furthermore, the thermal-hydraulic performance of the cross-flow PCHE is analyzed with different inlet conditions. Heat transfer and flow performance of the supercritical nitrogen is significantly affected by its thermal properties. It is observed that the heat transfer effectiveness increases as the inlet pressure of the cold fluid increases, which is due to the improvement of the overall nonuniformity and coordination angle of heat transfer coefficients. According to the performance evaluation criteria, the evaluation of the thermal-hydraulic performance of cross-flow PCHE is determined by inlet conditions of both cold and hot sides.</p>

RESEARCH OF DESIGN AND CALCULATION METHOD FOR GEOTHERMAL HEAT EXCHANGERS IN DIAPHRAGM WALLS

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

A Model of a Diaphragm Wall Ground Heat Exchanger

Development and application of a new calculation method for double spiral ground heat exchangers

Numerical Investigation on Three-fluid Heat Exchanger for Hybrid Energy Source Heat Pumps

Optimization of solution flow rate and heat transfer area allocation in the two-stage absorption heat exchanger system based on a complete heat and mass transfer simulation model

Analysis Of The Differential-Growth Method'S Potential For Designing Complex Heat-Transferring Walls For Compact Heat Exchanger

A Thermal Design Method for the Performance Optimization of Multi-Stream Plate-Fin Heat Exchangers

Concise algorithm for buried vertical pipe system design of ground-source heat pump systems

Thermal calculation method for direct-contact flue-gas-water condensation heat exchangers

Structural design method, validation, and performance analysis of an earth-air heat exchanger for greenhouses

Design and Factor Analysis of Buried Heat Exchangers

Testing a model of flow and heat transfer for u-shaped geothermal exchangers

Numerical Investigation on Thermal Performance of Ground Heat Exchangers Using Phase Change Materials As Grout for Ground Source Heat Pump System

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger

Improved Method and Case Study of Ground-Coupled Heat Pump System Design

Inverse Problem and Variation Method to Optimize Cascade Heat Exchange Network in Central Heating System

Methodology of design and analysis on the thermal hydraulic performance of the cross-flow printed circuit heat exchanger

APPLICATION OF GEO-THERMAL RESPONSE TEST IN THE DESIGN OF GROUND HEAT EXCHANGER

A systematic review on optimal analysis of horizontal heat exchangers in ground source heat pump systems

Progress in Design Calculations of Shell-and-tube Heat Exchangers