Abstract:Single shell segmental lining can withstand a maximum water head of about 50 m. If the water pressure exceeds this value, it is necessary to partially reduce groundwater pressure acting behind the tunnel lining.This paper presents a novel TBM tunnel drainage technology that employs adjustable pressure valves to regulate the volume of incoming water. This method not only reduces the impact of tunnel drainage on the surrounding groundwater environment but also effectively decreases the water pressure behind the lining, lowering the risk of structural damage and enhancing the load-bearing capacity of the lining. This represents an integration of prevention and drainage in the engineering concept of groundwater control.The study commenced with field experiments in the Daxiang Mountain Tunnel of the Fuzhou Intercity Railway, focusing on the effects of different drainage hole spacings and pressure valve settings on tunnel water inflow, pressure behind segmental linings, and strain on the linings' inner surfaces. A numerical model was subsequently constructed to compare and validate these field monitoring results, which demonstrated a high level of agreement. Finally, a parametric analysis was conducted, and the results indicate: (1) Although increasing the spacing between drainage holes effectively controls groundwater discharge, the resulting higher water gradient near these holes significantly increases bending moments at the foot of the side wall and invert of the lining, thus elevating the risk of structural disorders in the lining. (2) At segmental linings with drainage holes spaced at 3.6 m, the installation of pressure valves set to 400 kPa reduced the drainage volume from 2.18 m 3 /(D·m) to 1.56 m 3 /(D·m) compared to the full drainage scenario. This reduction satisfies the groundwater conservation requirements of the Daxiang Mountain area and significantly lowers the risk of structural damage to the lining caused by high water gradients near the drainage holes. Consequently, the load-bearing capacity of the segmental tunnel structure is effectively utilized. The research outcomes of this paper can offer guidance for the drainage countermeasure design in similar TBM tunnel projects.

Study on Water Pressure Distribution and Inner Force of Drainaged Segment Lining

Observed response of a shield-driven tunnel to fluctuations in river stage

STUDY OF GROUND HEAVE AND SUBSIDENCE INDUCED BY SHIELD TUNNELLING IN SOFT GROUND

Earth Pressure and Internal Forces of Tunnel Lining in Jet Grouting Reinforced Mud Stratum

Analytical Method for Segmental Tunnel Linings Reinforced by Secondary Lining Considering Interfacial Slippage and Detachment

Numerical analysis and field experiments of a new drainage system with pressure valves for single shield TBM

Fluid-solid coupling response of shield tunnel lining structure under high water pressure

Fluid-Solid Interaction-Based Mechanical Characteristics of Underwater Shield Tunnel

Full-Scale Experimental Study on the Effect of Ground Surcharge on the Stress and Deformation of Shield Tunnels

Analytical Solutions for Seepage Field of Underwater Tunnel

Mechanical Analysis of Segment Floating During Shield Tunnel Construction

Study on the Damage Mechanics and Dewatering Recovery Programs for Shield Tunnel

Analysis of Superimposed Stress of Surrounding Soil Due to Shield Tunneling

Full-scale experimental investigation on progressive failure characteristics of shield segmental lining connected through segmental joints containing ductile-iron joint panels

Analysis of water pressure distribution and optimization of waterproof-drainage system for tunnels in water-rich region

Structural Behavior of Triple-Layer Composite Lining of a Water Conveyance Tunnel: Insight from Full-Scale Loading Tests

Full-scale experiment for segmental linings of deep-buried shield tunnels bearing high inner water pressure: Comparison of mechanical behaviors of continuous- and stagger-jointed structures

Method to determine reduction factor of water pressure acting on tunnel linings using water-rock independent calculation methodology

Study of the Damage Mechanics and Dewatering Recovery Programs for the Shield Tunnel under the Yangtze River

Study on Mechanical Characteristics of Segmental Joints of a Large-Diameter Shield Tunnel under Ultrahigh Water Pressure

Research on Distribution of Initial Excess Pore Water Pressure Due to Shield Tunnelling