Abstract:Queue length is one of the important indexes to evaluate the operation efficiency of signalized intersection and also the key parameter of intersection signal control optimization. Traditional queue length estimation models are mostly based on fixed detection equipment, and the models assumptions are too harsh; there are certain limitations. Based on the probe vehicle data, this paper establishes a model of queue length estimation for signalized intersection based on shockwave theory. First, based on the speed and location data of the probe vehicle, the vehicle density is calculated to estimate the intersection stop line. A real-time calculation method of vehicle arrival rate is proposed to improve the applicability of the model. Then, based on the shockwave theory, the meeting time of the queue forming wave and the queue discharging wave are calculated after the green light is on. Finally, the queue length is summed in sections, including the distance between the last queued probe vehicle and the stop line during the red light period, the length of the subsequent vehicles arriving during the residual red light time, and the newly increased queue length within the queue discharging time. This paper uses the VISSIM software to simulate the actual intersection. The simulation results show that when the penetration of probe vehicle is 50%, 25%, and 10%, their corresponding mean absolute relative error are 11.27%, 27.77%, and 39.12%, respectively. It can be seen that with the increase of penetration, the error gradually decreases. The average absolute relative error is within the acceptable range. After analyzing the existing similar methods, although the accuracy of the method proposed in this paper does not reach the highest level, it has the advantages of simple operation, less computation, and good real-time computation. Relevant research results can provide support for traffic control at signalized intersections.

Queue Length Estimation Based on Floating Car Data

Queue Length Estimation for Signalized Intersections Using License Plate Recognition Data

Estimating Maximum Queue Length for Traffic Lane Groups Using Travel Times from Video-Imaging Data

High Time-Resolution Queue Profile Estimation at Signalized Intersections Based on Extended Kalman Filtering.

Queue Length Estimation Based on Probe Vehicle Data at Signalized Intersections

A Kalman Filter-Based Queue Length Estimation Method with Low-Penetration Mobile Sensor Data at Signalized Intersections

Real-Time Queue Length Estimation for Signalized Intersections Using Vehicle Trajectory Data

Vertical and Horizontal Queue Models for Oversaturated Signal Intersections with Quasi-Real-Time Reconstruction of Deterministic and Shockwave Queueing Profiles Using Limited Mobile Sensing Data

A Method for Queue Length Estimation in an Urban Street Network Based on Roll Time Occupancy Data

Kalman Filtering Method for Real-Time Queue Length Estimation in a Connected Vehicle Environment

Queue Length Estimation for Signalized Intersections under Partially Connected Vehicle Environment

Queue Length Estimation at Traffic Signals: Connected Vehicles with Range Measurement Sensors

A Ramp Queue Length Estimation Algorithm.

Freeway Travel-Time Estimation Based on Temporal–Spatial Queueing Model

Vehicle Queue Length at Signal Controlled Intersection

Estimation Method of Road Queue Back

Queue Length Estimation Using Probe Vehicle Data for a Congested Arterial Road

Queue Profile Identification at Signalized Intersections with High-Resolution Data from Drones

Lane-Based Real-Time Queue Length Estimation Using License Plate Recognition Data

Fuzing License Plate Recognition Data and Vehicle Trajectory Data for Lane-Based Queue Length Estimation at Signalized Intersections

Queue Length Estimation at Isolated Intersections Based on Intelligent Vehicle Infrastructure Cooperation Systems.