Abstract:Queue length is one of the important indexes to evaluate the operation efficiency of signalized intersection and also the key parameter of intersection signal control optimization. Traditional queue length estimation models are mostly based on fixed detection equipment, and the models assumptions are too harsh; there are certain limitations. Based on the probe vehicle data, this paper establishes a model of queue length estimation for signalized intersection based on shockwave theory. First, based on the speed and location data of the probe vehicle, the vehicle density is calculated to estimate the intersection stop line. A real-time calculation method of vehicle arrival rate is proposed to improve the applicability of the model. Then, based on the shockwave theory, the meeting time of the queue forming wave and the queue discharging wave are calculated after the green light is on. Finally, the queue length is summed in sections, including the distance between the last queued probe vehicle and the stop line during the red light period, the length of the subsequent vehicles arriving during the residual red light time, and the newly increased queue length within the queue discharging time. This paper uses the VISSIM software to simulate the actual intersection. The simulation results show that when the penetration of probe vehicle is 50%, 25%, and 10%, their corresponding mean absolute relative error are 11.27%, 27.77%, and 39.12%, respectively. It can be seen that with the increase of penetration, the error gradually decreases. The average absolute relative error is within the acceptable range. After analyzing the existing similar methods, although the accuracy of the method proposed in this paper does not reach the highest level, it has the advantages of simple operation, less computation, and good real-time computation. Relevant research results can provide support for traffic control at signalized intersections.

Queue Length Estimation Using Probe Vehicle Data for a Congested Arterial Road

Queue Length Estimation for Signalized Intersections Using License Plate Recognition Data

Various Methods for Queue Length and Traffic Volume Estimation Using Probe Vehicle Trajectories

Real-Time Queue Length Estimation for Signalized Intersections Using Vehicle Trajectory Data

Queue Length Estimation Based on Probe Vehicle Data at Signalized Intersections

Estimating Maximum Queue Length for Traffic Lane Groups Using Travel Times from Video-Imaging Data

A Method for Queue Length Estimation in an Urban Street Network Based on Roll Time Occupancy Data

Maximum Likelihood Estimation of Probe Vehicle Penetration Rates and Queue Length Distributions From Probe Vehicle Data

Estimation of Queue Lengths, Probe Vehicle Penetration Rates, and Traffic Volumes at Signalized Intersections using Probe Vehicle Trajectories

A Ramp Queue Length Estimation Algorithm.

Estimation of urban traffic state with probe vehicles

Queue Length Estimation of Intersection Traffic Flow Undera Connected Vehicles Environment

Cycle-Based Queue Length Estimation for Signalized Intersections Using Sparse Vehicle Trajectory Data

Vehicle Queue Length at Signal Controlled Intersection

Cycle-Based End of Queue Estimation at Signalized Intersections Using Low-Penetration-Rate Vehicle Trajectories

Real-time Estimation of Arterial Travel Time under Congested Conditions

Real-time Queue Length Estimation for Congested Signalized Intersections

Real-time Estimation of Vehicle Counts on Signalized Intersection Approaches Using Probe Vehicle Data

Queue Length Estimation Based on Floating Car Data

Probe vehicle lane identification for queue length estimation at intersections

Methods for Estimating Vehicle Queues at a Marine Terminal: A Computational Comparison