Abstract:In this dissertation, the relationships between structure-mechanical properties-deformation mechanisms in face-centered cubic (FCC) and body-centered cubic (BCC) metallic nanowires have been studied using in situ TEM nanomechanical testing. It is well known that smaller is stronger and the widely-observed size effect is believed to arise from dislocation interactions inside nanocrystals. However, the interaction mechanisms in small-volume nanocrystals remain unexplored. Here, it was found that surface-nucleated dislocations can strongly interact inside the confined volume of Au nanowires, which led to a new type of dislocation-originated stacking fault tetrahedra (SFT), at variance to the widely-believed vacancy-originated SFT. The atomic-scale processes of nucleation, migration and annihilation of dislocation-originated SFT were revealed, shedding new light onto the strain hardening and size effect in small-volume materials. Although nanoscale twinning is an effective mean to enhance the strength of metals, twin-size effect on the deformation and failure of nanotwinned metals remains largely unexplored, especially at the minimum twin size. Here, a new type of size effect in nanotwinned Au nanowires is presented. As twin size reaches the angstrom-scale, Au nanowires exhibit a remarkable ductile-to-brittle transition that is governed by the heterogeneous-to-homogeneous dislocation nucleation transition. Quantitative measurements show that approaching such a nanotwin size limit gives rise to the ultra-high strength in Au nanowires, close to the ideal strength limit of perfect Au. Twinning is a fundamental deformation mode that competes against dislocation slip in crystals. At the nanoscale, higher stresses are required for plastic deformation than that in bulk, which favors twinning over dislocation slip. Indeed, deformation twinning has been well-documented in FCC nanocrystals. However, it remains unexplored in BCC nanostructures. Here, it shows that twinning is the dominant deformation mode in BCC-tungsten nanocrystals. A competition between twinning and dislocation slip occurs when changing the loading orientations, attributed to the defect growth controlled plasticity in BCC nanocrystals. Several important commonalities and differences in FCC and BCC nanocrystals deforming at nanoscale are further proposed. The results from this dissertation advance fundamental understanding of plastic deformation in a broad class of metals and alloys, and are of technological importance for degradation control and future design of ultra-strength nanomaterials.

Surface and Interface Controlled Yielding and Plasticity in Fivefold Twinned Ag Nanowires

Numerical Exploration of Plastic Deformation Mechanisms of Copper Nanowires with Surface Defects

Atomistic Exploration of Deformation Properties of Copper Nanowires with Pre-Existing Defects

Bending Properties of Ag Nanowires with Pre-Existing Surface Defects

Influence of Pre-Exsiting Surface Defects on the Vibrational Properties of Ag Nanowires

Atomistic Numerical Investigation of Single-crystal Copper Nanowire with Surface Defects

Exploration of the Defect’s Effect on the Mechanical Properties of Different Orientated Nanowires

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Surface Stress Effects On The Yield Strength In Nanotwinned Polycrystal Face-Centered-Cubic Metallic Nanowires

Five-fold Twin and Surface Groove-Induced Abnormal Size- and Temperature-Dependent Yielding in Ag Nanowires

In Situ TEM Study on the Nanomechanical Behaviors of Metallic Nanowires

Numerical Exploration Of The Defect'S Effect On Mechanical Properties Of Nanowires Under Torsion

Bending-induced Deformation Twinning in Body-Centered Cubic Tungsten Nanowires

Void-assisted Plasticity in Ag Nanowires with a Single Twin Structure.

Strain Hardening and Size Effect in Five-fold Twinned Ag Nanowires.

Investigation on the Mechanical Behavior of Fivefold Twinned Silver Nanowires

Strong Hall-Petch Type Behavior in the Elastic Strain Limit of Nanotwinned Gold Nanowires

A study on the effects of twin boundaries and surface morphology on deformation behaviours of silver nanowires

Mechanical Behavior of Metallic Nanowires with Twin Boundaries Parallel to Loading Axis

Orientation- and Microstructure-Dependent Deformation in Metal Nanowires under Bending

Atomistic Simulation of Yield Mechanism of Single Crystal Copper Nanowires