Abstract:Abstract Design of an alkaline-surfactant-polymer (ASP) process requires knowledge of the amount of soap formed under alkaline conditions from naphthenic acids in the crude oil. We show here for several crude oils that the acid number determined by nonaqueous phase titration is approximately twice that found by hyamine titration of a highly alkaline aqueous phase used to extract soaps from the crude oil. This acid number by soap extraction should provide a better estimate than nonaqueous phase titration. This soap interacts with the injected surfactant to form surfactant films and microemulsion droplets during an ASP process. In a previous paper (Liu et al., 2006), an unusually wide range of salinities of ultra-low oil-water interfacial tensions (IFTs) was found for one alcohol-free crude oil/anionic surfactant system under alkaline conditions where naphthenic soaps were present. This surprising and favorable behavior has now been found to exist with the same surfactant blend and another crude oil. In the same paper, a one-dimensional simulator for the ASP process was presented. Here this ASP simulator has been used for various acid contents, injected surfactant concentrations, slug sizes and salinities to show that high recoveries of waterflood residual oil (>90%) can be expected for a wide range of near-optimal (Winsor III) and under-optimum (Winsor I) conditions for a constant salinity process, even with relatively small slug sizes. A key factor leading to this good performance is development of a gradient in soap-to-surfactant ratio, which assures that a displacement front with ultralow IFT forms and propagates through the formation. Similar high recoveries can be attained for certain over-optimum (Winsor II) conditions but only for much larger slug sizes owing to the tendency for surfactant to partition into the oil phase and become retarded. Large dispersion such as might be expected for field conditions can significantly reduce recovery for small surfactant slugs even for near-optimal and under-optimum conditions. However, this problem can be overcome by injecting the slug and/or drive at salinities below reservoir salinity, thereby creating a salinity gradient. Introduction Alkaline-surfactant processes offer considerable promise for enhanced oil recovery (EOR). The alkali converts naphthenic acids in the crude oil to soaps. The combination of the soaps and a suitably chosen injected surfactant reduces interfacial tensions to ultralow values, where residual oil can be mobilized and oil trapping prevented. As discussed more fully in a previous paper (Liu et al, 2006), the alkali reduces surfactant adsorption. Soaps are usually too lipophilic to produce ultralow tensions at reservoir conditions. Effective, hydrophilic, injected surfactants can be injected in an alkaline-surfactant process at salinities below their optimal salinities for oil recovery when used in the absence of alkali (Nelson, et al., 1984). The result is to further reduce adsorption and to facilitate finding surfactant slug compositions where addition of polymer to provide adequate mobility control does not cause undesirable separation into polymer-rich and surfactant-rich phases. The drive is also a polymer solution, so that the process is of the alkaline-surfactant-polymer (ASP) type. Liu et al (2006) presented phase behavior, interfacial tensions (IFTs), adsorption isotherms, and results of ASP experiments in silica and dolomite sand packs for a system with a particular surfactant blend (NI blend) and a West Texas crude oil (Yates). The alkali was sodium carbonate, and all experiments were conducted at ambient temperature. A mixture of a propoxylated sulfate and an internal olefin sulfonate, the NI blend was used with no added alcohol or other cosolvent. It was a single-phase micellar solution for salinities up to approximately its optimal salinity with the crude when minimal soap is present, making it suitable for injection at lower salinities in an ASP process, as mentioned above.

Low Interfacial Tension Behavior Between Organic Alkali/Surfactant/Polymer System and Crude Oil

Experimental Study of Enhancing Oil Recovery with Weak Base Alkaline/Surfactant/Polymer

Interfacial tension reduction mechanism by alkaline-surfactant-polymer at oil-water interface from experimental and molecular dynamics approaches

Zwitterionic-nonionic compound surfactant system with low chromatographic separation effect for enhanced oil recovery

Structure-activity relationship of anionic-nonionic surfactant for reducing interfacial tension of crude oil

Dynamic Interfacial Tension Between Crude Oil and Octylmethylnaphthalene Sulfonate Solution

Interfacial behavior Between dodecyl betaine-heavy alkyl benzene sulfonate-alkali mixed aqueous system and daqing crude oil

Interaction between polymer and anionic/nonionic surfactants and its mechanism of enhanced oil recovery

Favorable Attributes of Alkali-Surfactant-Polymer Flooding

Alkaline/Surfactant/Polymer Processes: Wide Range of Conditions for Good Recovery

Study on Microscopic Oil Displacement Mechanism of Alkaline-Surfactant-Polymer Ternary Flooding

A New Logistically Simple Solution for Implementing Alkali-Surfactant-Polymer/Alkali-Cosolvent-Polymer in Difficult Environments: Evaluation of Concept with High Total Acid Number Viscous Crude Oil

Ultralow Interfacial Tension Achieved by Extended Anionic Surfactants with a Short Hydrophobic Chain

Emulsification and interfacial characteristics of different surfactants enhances heavy oil recovery: experimental evaluation and molecular dynamics simulation study

Dynamic interfacial behavior between crude oil and octylmethylnaphthalene sulfonate surfactant flooding systems

Interfacial Tension Behavior of Double Long-Chain 1,3,5-Triazine Surfactants for Enhanced Oil Recovery

Polyetheramine enhanced biosurfactant/biopolymer flooding for enhanced oil recovery

ASP Process: Wide Range of Conditions for Good Recovery

Studies on interfacial tensions of betaine and anionic-nonionic surfactant mixed solutions

Dynamic Interfacial Tension Between Crude Oil and Novel Surfactant Flooding Systems Without Alkali

Spontaneous emulsification induced by a novel surfactant-polymer compound system and its application to enhance oil recovery