Abstract:Due to the existence of diffraction limit as the basic characteristic of light, the lasing on subwavelength scale cannot be achieved by traditional methods. In order to break this diffraction limit, a stacked structure composed of metal, dielectric layer and semiconductor was designed in this paper to achieve lasing on the deep subwavelength scale and its influence on the propagation mode was discussed. In terms of structural design, we used silver, a metal with low dielectric constant, as the substrate, a 10 nm-thick LiF layer as the dielectric layer, and a ZnO semiconductor nanowire with hexagonal section as the high-dielectric-constant layer. We adopted the finite-difference eigen mode and Finite-Difference Time-Domain (FDTD) method to perform optical simulation of the designed structure. First, by changing the nanowire diameter and using the finite eigen mode, the optical modes in the dielectric layer were analyzed to obtain four mode distributions. Then the effective refractive indexes and losses of the four optical modes at different nanowire diameters were used to calculate the corresponding waveguide propagation distances and lasing threshold gains. Finally, the three-dimensional FDTD method was introduced to simulate the electric field distribution of the four modes during the steady-state laser emissionin of the nanowire. The results showed that there were hybrid plasmonic mode and hybrid electric mode in the dielectric layer between the nanowire and the metal substrate. When the diameter of ZnO nanowire was smaller than 75 nm, there was no effective physical optical mode, that is, both the hybrid plasmonic mode and the hybrid electric mode were cut off. When the nanowire diameter was larger than 75 nm, the hybrid plasmonic mode could effectively exist. The hybrid electric mode did not appear until the nanowire diameter reached 120 nm. Although the hybrid plasmonic mode could be better confined to the dielectric layer, its loss was too large and its propagation distance was relatively small. In addition, the hybrid electric mode traveled a longer distance than hybrid plasmonic mode. At the given diameter of the micron wire (D = 240 mu m), the hybrid electric mode propagated for over 50 mu m. In conclusion, the hybrid leaky mode on the deep subwavelength scale can break the optical diffraction limit and realize lasing.

Modal properties of triangular metal groove/wedge based hybrid plasmonic structures for laser actions at deep-subwavelength scale

Triangular Metal Wedge/groove Based Hybrid Plasmonic Structures for Low-Threshold Deep-Subwavelength Lasing

Deep-subwavelength light confinement and transport in hybrid dielectric-loaded metal wedges: Deep-subwavelength light transport in hybrid metal wedges

Deep-Subwavelength Hybrid Plasmonic Waveguide with Metal-Semiconductor Ribs for Nanolaser Applications

Hybrid Plasmonic Waveguides for Low-Threshold Nanolaser Applications

Nanowire Based Hybrid Plasmonic Structures for Low-Threshold Lasing at the Subwavelength Scale

Study of Plasmonic Nanolaser Based on the Deep Subwavelength Scale

Low-loss Hybrid Plasmonic Modes Guided by Metal-Coated Dielectric Wedges for Subwavelength Light Confinement.

A Hybrid Plasmonic Waveguide for Nanolaser Applications

Deep-subwavelength coplanar plasmonic laser based on an edge-coupled hybrid plasmon waveguide

Highly confined surface plasmon polariton modes guided by triangular (V-shape) metal/dielectric grooves at 1550nm

Research of a hybrid plasmonic nanolaser at ultraviolet band

Single-Nanorod Plasmon Nanolaser: A Route Toward A Three-Dimensional Ultraconfined Lasing Mode

Hybrid wedge plasmon polariton waveguide with good fabrication-error-tolerance for ultra-deep-subwavelength mode confinement.

Simulation Design of a Low Threshold Hybrid Plasmonic Nanolaser

Hybrid Plasmon Polariton Guiding with Tight Mode Confinement in a V-shaped Metal/dielectric Groove

Hybrid Plasmonic Structures Based on Cds Nanotubes: A Novel Route to Low-Threshold Lasing on the Nanoscale

Nanoscale Active Hybrid Plasmonic Laser with a Metal-Clad Metal–insulator–semiconductor Square Resonator

Hybrid Plasmonic Leaky-Mode Lasing on Subwavelength Scale

Low-Threshold Plasmonic Nanolaser Structure Based on Coupled Nanowires

Fabrication-error-tolerant, hybrid wedge plasmon polariton waveguides for ultra-deep-subwavelength mode confinement at 1550nm wavelength