Experimental and Numerical Study on the Pin-Load Distribution of Multiple-Bolted Joints

LIU Xiangdong,LI Yazhi,SHU Huai,LIU Xingke

DOI: https://doi.org/10.13801/j.cnki.fhclxb.2013.01.007

2013-01-01

Abstract:Test and finite element analysis were carried out to characterize the pin-load distribution of multiple-bolted metal-to-composite fastener joints.The specimens are the single-lap and double-lap joints with an array of three bolts and subjected to tension loading.The surface strains at certain cross-sections of the metallic plates were measured using the strain gage technique.The pin-load fractions of the multiple bolts were then estimated indirectly using the measured strains.Two-and-three dimensional finite element models were also constructed to calculate those strains and the pin-loads.The calculated strains agree well with the measurement,whereas significant difference is observed between the pin-load fraction results of both methods.The investigation reveals that the way to determine the pin-load distributions ratios according to the plate surface strains is not able to account for the built-in effects of additional bending moment concurrently with the tension loading.The authors believe that the numerical calculation to estimate the pin-load fractions,based on finite element modeling which has been validated by the surface strain measurement,is a technically feasible approach.The two-dimensional models formed by beam and shell elements are of satisfied accuracy to determine the pin-load distributions.