Abstract:Niobium oxides are promising materials for applications within various research fields, especially as electrocatalysts for various chemical reactions. The tuning of the synthetic parameters can achieve a successful compromise between morphology and structure, aiming to obtain certain properties. Hence, this study aimed to investigate the influence of hydrothermal synthesis parameters on the morphology and structure of niobium oxide growth on a niobium metallic plate. The effect of annealing on the material performance was also evaluated. Afterward, the most crystalline sample was tested for the electrochemical determination of dissolved oxygen, a fundamental reaction in corrosion, biomedicine, and environmental monitoring. This is the first work using this material configuration as an electrochemical sensor. The hydrothermal synthesis produced nanorods formed by poorly crystalline, acidic, hydrated Nb2O5. Increasing the mineralizer concentration could increase the crystallinity and the nanorod growth rate, but it could also promote a lack of structural and morphological uniformity throughout the surface. Heat treatment allowed the increase in crystallinity and favored orthorhombic Nb2O5. Raman spectroscopy revealed that, at the first moment, acidic, hydrated niobium oxide structures were formed as precursors of crystalline niobium oxide that would be developed with longer reaction times and a higher mineralizer concentration. The obtained niobium oxide showed electrocatalytic activity toward the oxygen reduction reaction, with comparable performance between the samples with and without heat treatment. At all analyzed pH values, the amperometric response was linearly correlated with the dissolved oxygen concentration. pH influenced the sensitivity of the material; a maximum sensitivity of 0.0417 mA/cm2·mg/L O2 was achieved at pH = 6. The participation of the acidic functionalities of the surface in the ORR reaction was confirmed by Raman spectroscopy.

Hydrothermally formed functional niobium oxide doped tungsten nanorods.

Synthesis of 1d and Heavily Doped Zn1-Xcoxo Six-Prism Nanorods: Improvement of Blue-Green Emission and Room Temperature Ferromagnetism

Remarkable Synergy Effect of Cu–Nb Oxide Nanorods Toward Electrocatalytic Nitrogen Reduction: the Enhanced Mass and Electron Transfer

Optimization of hydrogen-ion storage performance of tungsten trioxide nanowires by niobium doping

Direct Growth of Tungsten Oxide Nanorods from Heated Tungsten Foils

Niobium Oxide Nanorods Obtained by Hydrothermal Synthesis—Structure, Morphology, and Electrochemical Detection of Oxygen Via Oxygen Reduction Reaction

Improved Electrochromic Performance of WO3 Films with Size Controlled Nanorods

Novel Route to WO<i><sub>x</sub></i>Nanorods and WS<sub>2</sub>Nanotubes from WS<sub>2</sub>Inorganic Fullerenes

A Simple Method for the Synthesis of Tungsten Trioxide Nanorods Array Without Catalyst

Synthesis and Electrical Characterization of Tungsten Oxide Nanowires

Organometallic-like localization of 4d-derived spins in an inorganic conducting niobium suboxide

Easy Growth of Large-Area Tungsten Oxide Nanostructures and Their Field Emission Properties

The effects of Ni/Cu co-doped ZnO nanorods: structural and optoelectronic study

Oxygen-vacancy-induced Green Emission and Room-Temperature Ferromagnetism in Ni-doped ZnO Nanorods

Nanostructured ZnO: from Monodisperse Nanoparticles to Nanorods

Fabrication, Structure, and Photocatalytic Activities of Boron-Doped Zno Nanorods Hydrothermally Grown on Cvd Diamond Film

Preparation and Characterization of Tungsten-substituted Molybdenum Disulfide Nanorods

Effect of Co/Nd co-doping on the structural, optical, and morphological properties of ZnO nanorods grown on silicon substrate Si (100) by hydrothermal method

Morphology, optical and magnetic properties of Zn1-xNixO nanorod arrays fabricated by hydrothermal method

Hydrothermal Synthesis Of Multielemental Bimetallic Mo1.8w16.2o49 Nanorods

Synthesis and Physical Characteristics of Undoped and Potassium-Doped Cubic Tungsten Trioxide Nanowires through Thermal Evaporation