Prepare of Oxygenated Biofuels by Catalytic Hydrogenation Using Raney-Ni Catalyst
Xu Ying,Long Jinxing,Zhang Limin,Chang Jiamin,Lü Wei,Liu Qiying,Fu Juan,Wang Tiejun,Ma Longlong,Zhang Qi
DOI: https://doi.org/10.3969/j.issn.1002-6819.2014.24.031
2014-01-01
Abstract:Bio oil, for its simple preparation and low cost, had the potential to be one kind of substitute liquid fuel. In view of its high temperature, H2 pressure, and high oxygen content, hydrodeoxygenation (HDO) is very critical for hydrocarbon fuel. Upgrading the light phase of bio-oil might be a potential method and stable oxygenated compounds might be a kind of potential fuel for the application of bio-oil. In this paper, a Raney Ni catalyst was used for hydrogenating bio oil to saturated alcohols in the high pressure reaction kettle. The influences of temperature (100-180℃), initial pressure of hydrogen (4-8 MPa), the dosages and the recycle usage of the catalyst on the hydrogenation of bio-oil over the self-made Raney-Ni catalyst were discussed. X-ray Diffraction, Brunauer Emmett Teller, and a scanning electron microscope were used to investigate the deactivation mechanism. The results indicated that the reaction temperatures and the initial pressures of the hydrogen gas had an obvious effect on the conversion of the light composition of the bio oil. With the increasing of the reaction temperature to 140℃and the initial pressure to 6 MPa, the yield of saturated alcohols increased and reached the highest point of 53.51%. Meanwhile, the total content of stable alcohols and esters reached 64.62%. At this condition, there was no aldehyde detected in the product, and nearly 40%of the ketones were hydrogenated to alcohols. And also there was 1.77%of ether detected in the products which accounts for the dehydration happening from alcohols. With the increasing of temperature, the conversion of phenol increased. When the dosage of the catalyst increased from 0.5 g to 1 g, the content of saturated alcohols in the product increased from 25.42% to 51.89%. Over 0.5 g of Raney Ni catalyst, there were some unstable ketone compounds such as 1-hydroxy-butanone, 3-hydroxy-butanone, and hydroxyl-acetone in the products. When the dosage of Raney Ni catalyst increased, the content of saturated alcohols in the upgraded bio oil was little changed. Over fresh and once-used Raney Ni catalysts, the content of saturated alcohols decreased from 53.51%to 29.20%. The XRD results showed that the three characteristics of the diffraction peak intensity decreased significantly, and the heterogeneous metal skeleton crystal structure of the Raney Ni catalyst collapsed after use. The SEM results showed that after the hydrogenation reaction, the catalyst presented a black honeycomb solid surface and the activity on the surface was covered by coking. The deactivation of the catalyst may relate to the covering of the catalyst pore and the coking on the catalyst channel, which leads to a decrease of the catalyst’s activity and a reduction of the reaction efficiency. During the upgrading process, the ketones and the aldehydes compounds could be hydrogenated to alcohols, and the phenols could be hydrogenated to cyclohexanol and its derivatives. Apart from the hydrogenation reaction, the esterifications existed during the process, and the contents of acids decreased after hydrogenation to some extent. Compared with hydrocarbon fuel, oxygenated fuel for its good combustion performance becomes more popular. It might be a potential and novel way of upgrading bio-oil to oxygenated fuel.