Bioconversion of beetle-killed lodgepole pine using SPORL: Process scale-up design, lignin coproduct, and high solids fermentation without detoxification

Haifeng Zhou,JunYong Zhu,Xiaolin Luo,Shaoyuan Leu,Xiaolei Wu,Roland Gleisner,Bruce S. Dien,Ronald E. Hector,Dongjie Yang,Xueqing Qiu,Eric G. Horn,José F. Negrón
DOI: https://doi.org/10.1021/ie402873y
2013-01-01
Industrial & Engineering Chemistry Research
Abstract:Mountain pine beetle killed Lodgepole pine (Pinus contorta Douglas ex Loudon) wood chips were pretreated using an acidic sulfite solution of approximately pH = 2.0 at a liquor to wood ratio of 3 and sodium bisulfite loading of 8 wt % on wood. The combined hydrolysis factor (CHF), formulated from reaction kinetics, was used to design a scale-up pretreatment on 2000 g wood chips at a relatively low temperature of 165 degrees C that reduced furan formation and facilitated high solids saccharification and fermentation. The pretreated solids and liquor were disk milled together to result in a biomass whole slurry of 25% total solids. The whole biomass slurry was directly used to conduct simultaneous enzymatic saccharification and combined fermentation (SSCombF) using a commercial cellulase and Saccharomyces cerevisiae YRH400 without detoxification. A terminal ethanol titer of 47.1 g L-1 with a yield of 306 L (tonne wood)(-1), or 72.0% theoretical, was achieved when SSCombF was conducted at an unwashed solids loading of 18%. The lignosulfonate (LS) from SPORL was highly sulfonated and showed better dispersibility than a high purity commercial softwood LS, and therefore has potential as a directly marketable coproduct.
What problem does this paper attempt to address?