Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Dual-templating Synthesis of Three-Dimensionally Ordered Macroporous La0.6Sr0.4MnO3-supported Ag Nanoparticles: Controllable Alignments and Super Performance for the Catalytic Combustion of Methane

Three-Dimensionally Ordered Macroporous La0.6Sr0.4MnO3 Supported Ag Nanoparticles for the Combustion of Methane

High Performance Au–Pd Supported on 3D Hybrid Strontium-Substituted Lanthanum Manganite Perovskite Catalyst for Methane Combustion

Three-dimensionally Ordered Macroporous La0.6Sr0.4MnO3 with High Surface Areas: Active Catalysts for the Combustion of Methane

Facile Synthesis of Hollow Hierarchical Ni/γ-Al2O3 Nanocomposites for Methane Dry Reforming Catalysis

Catalysis: Enhanced Catalytic Efficiency of Pt Nanoparticles Supported on 3D Ordered Macro‐/Mesoporous Ce0.6Zr0.3Y0.1O2 for Methane Combustion (small 20/2015)

AuPd/Co3O4/3DOM MnCo2O4: Highly active catalysts for methane combustion

Enhanced Catalytic Efficiency of Pt Nanoparticles Supported on 3D Ordered Macro-/Mesoporous Ce0.6 Zr0.3 Y0.1 O2 for Methane Combustion.

Silver–Cobalt Oxides Derived from Silver Nanoparticles Deposited on Layered Double Hydroxides for Methane Combustion

Pt Nanoparticles Embedded in Colloidal Crystal Template Derived 3D Ordered Macroporous Ce0.6Zr0.3Y0.1O2: Highly Efficient Catalysts for Methane Combustion

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

One-Step Synthesis of Nanostructured Cu–Mn/TiO 2 via Flame Spray Pyrolysis: Application to Catalytic Combustion of CO and CH 4

Facile synthesis of mesoporous Co3O4 nanoflowers for catalytic combustion of ventilation air methane

Strong Morphological Effect of Mn3O4 Nanocrystallites on the Catalytic Activity of Mn3O4 and Au/Mn3O4 in Benzene Combustion.

Robust Nanosheet-Assembled Al2O3-supported Ni Catalysts for the Dry Reforming of Methane: the Effect of Nickel Content on the Catalytic Performance and Carbon Formation

Facile Synthesis of Mn-Fe/CeO2 Nanotubes by Gradient Electrospinning and Their Excellent Catalytic Performance for Propane and Methane Oxidation.

Creating Atomically Iridium-Doped PdO x Nanoparticles for Efficient and Durable Methane Abatement

Anchoring Pt-Doped PdO Nanoparticles on γ-Al 2 O 3 with Highly Dispersed La Sites to Create a Methane Oxidation Catalyst

Three-Dimensional Ordered Mesoporous Mno2-Supported Ag Nanoparticles for Catalytic Removal of Formaldehyde

Synthesis of Three-Dimensionally Ordered Macro-/Mesoporous Pt with High Electrocatalytic Activity by A Dual-Templating Approach

Lattice Distortion in Co3O4/Mn3O4-Guided Synthesis via Carbon Nanotubes for Efficient Lean Methane Combustion