Abstract:Direct contact condensation (DCC) is a phenomenon observed when steam interacts with subcooled water, exhibiting higher heat and mass transfer rates compared to wall condensation. It has garnered significant interest across industries such as nuclear, chemical, and power due to its advantageous characteristics. In the context of pressure-relief tanks, understanding and optimizing the DCC process are critical for safety and efficiency. The efficiency of pressure-relief tanks depends on the amount of steam condensed per unit of time, which directly affects their operational parameters and design. This study focuses on investigating the direct gas–liquid contact condensation process in pressure-relief tanks using computational fluid dynamics (CFD). Through experimental validation and a sensitivity analysis, the study provides insights into the influence of inlet steam parameters and basin temperature on the steam plume characteristics. Furthermore, steady-state and transient calculation models are developed to simulate the behaviour of the pressure-relief tank, providing valuable data for safety analysis and design optimization. There is a relatively high-pressure area in the upper part of the bubble hole of the pressure-relief tube, and the value increases as it is closer to the holes. The steam velocity in the bubbling hole near the 90° elbow position is higher. This study contributes to the understanding of steam condensation dynamics in pressure-relief tanks. When the steam emission and pressure are fixed, the equilibrium temperature increases linearly as the initial temperature increases (where a = 1, b = 20 in y = a x+ b correlation), the equilibrium pressure increases nearly exponentially, and the equilibrium gas volume decreases. When the steam emission and initial temperature are fixed, the equilibrium temperature does not change as the steam discharge pressure increases. The correlations between the predicted equilibrium parameters and the inlet steam parameters and tank temperature provide valuable insights for optimizing a pressure-relief tank design and improving the operational safety in diverse industrial contexts.

Experimental Study of Direct Contact Steam Condensation in Structured Packing

Direct-Contact Condensation of Hydrocarbon Mixtures in A Structured Packing Bed

Hydrodynamics of New Structured Packings: an Experimental and Micro-scale CFD Study

Exploring the Essence of Three-Phase Packed Distillation: Substantial Mass Transfer Computation

An Experimental Study on the Dehumidification Performance of a Counter Flow Liquid Desiccant Dehumidifier

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental investigation on the effect of direct contact condensation regime on thermal stratification

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Numerical Study on Direct-Contact Condensation of Vapor in Cold Water

Flow Pattern, Heat Transfer and Frictional Pressure Drop Investigation of R365mfc Condensation in a Micro-Structured Corrugated Gap with Mixed Angles

Experimental investigation on interface characteristics and heat transfer during bubble condensation in narrow rectangular channel

Effect of Non-Condensation Gas on Heat Transfer of Direct Contact Condensation

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

CFD Simulation of Flow and Mass Transfer in Structured Packing Distillation Columns

Numerical simulation on the effect of non-condensable gas on direct contact condensation of steam jet in a narrow pipe

Experimental Investigation of Condensation in Micro-Fin Tubes of Different Geometries

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

Study on thermodynamics and flow characteristics of jet condensate in subcooled flowing liquid

Condensation heat transfer in presence of non-condensable gases on a vertical tube bundle