Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Mixing of Liquids with Different Viscosities and Densities in a Helical Ribbon Impeller Stirred Tank

Experimental Study on Micromixing Characteristics of Novel Large-Double-blade Impeller

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Numerical Study on the Synergistic Mechanism of Coaxial Mixers in Dense Solid-Liquid Mixing Systems

Experimental Study on Micromixing Characteristics of Coaxial Mixer in Solid–Liquid Systems

Numerical investigation on the intensification of coaxial slurry mixing systems

Numerical Study on Solid Suspension Characteristics of a Coaxial Mixer in Viscous Systems

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

Mixing process of high-viscosity xanthan in different agitation system

Laminar mixing enhanced by flexible impeller in high-viscosity fluid stirred tank

Mixing Time in Stirred Tank of Three-phase Gas-Liquid-Floating Particle Systems

Influence of Impeller and Mixing Tank Shapes on the Solid–Liquid Mixing Characteristics of Vanadium-Bearing Shale Based on the DEM-VOF Method

Gas–liquid mixing performance of a non‐Newtonian fluid in a multiple‐impeller agitated tank

Intensification of Liquid-liquid Heterogeneous Micromixing for Preparing Biodiesel by Hydrodynamic Cavitation

Simultaneous saccharification and ethanol fermentation at high corn stover solids loading in a helical stirring bioreactor.

Numerical Simulation of Mixing Processes for Pseudoplastic Fluids in Industrial Scale Stirred Tank Agitated by Two Types of Impellers

Experimental study on gas-liquid flow regimes of coaxial mixers equipped with a Rushton/pitched blade turbine and anchor

Liquid mixing in eccentric stirred tank

Energy efficiency analysis for high-viscosity fluid mixing enhanced by flexible impeller