Abstract:Diffusers are devices found in several engineering applications and their performance and design are object of numerous investigations. However, relatively few investigations have been dedicated to diffusers operating at low and moderate Reynolds numbers. In this regime, the flow could be laminar, turbulent or transitional, and the aerodynamic performance of the diffuser becomes highly dependent on the specific value of the Reynolds number and inlet conditions. In particular, the present study focuses on evaluating the role of inlet conditions on the performance and flow behaviour of two-dimensional diffusers on this specific Reynolds number regime ( ). Furthermore, the diffuser discharges in a stationary chamber and it does not present a tail-pipe configuration, a condition that has not found a clear presence in the existing literature so far. A numerical investigation of two-dimensional plane diffusers was performed at for 9 different cases, combined varying the inlet turbulence intensity (0.05, 3, and 10 percent), and the velocity profile, characterised by different blockage factors (0, 0.05 and 0.33). For each case, the divergence angle ranged from 0 to 30 degrees, and several URANS simulations were performed using the Transitional SST model that accounts for the possible transition of the boundary layer. The results show that the design recommendations valid for high Reynolds number diffusers with a thin boundary layer are not always applicable, and extreme caution must be exercised when dealing with operating conditions that do not ensure a sufficiently high turbulence level at the inlet. The divergence angles of the stall regimes are shown, and performance indicators (e.g. pressure-recovery coefficients) are reported. These reveal a strong decrement (up to 60 percent) of the pressure recovery on reducing turbulence intensity from 10 percent to 0.05 percent. The blockage factor of the velocity profile has an important effect on performance as well. In order to simplify the comparison between the different blockage factors, a modified effectiveness was employed to account for the distortion introduced by a non-uniform inlet velocity profile.

Dimensionless performance and characteristic numbers of reverse flow diverters during reverse flow mode

Dimensionless Performance and Design Guidelines for Reverse-Flow Diverters During Reverse-Flow Mode

Performance Curve Available for Non-Steady Flow Through Venturi-like Reverse Flow Diverter

Output Flow Determination of Reverse Flow Diverters in Reverse Flow Mode Based on Pressure Data

Experimental Study on Fundamental Performance of Reverse Flow Diverters

Cavitation Performance of the Low Specific-speed Centrifugal Pump with Radial Reflux Balance Hole

Prediction of the Pumping Capacity for Reverse-Flow Diverter Pumps

Experimental Study of the Flow Rectification Performance of Conical Diffuser Valves

Flow Field Simulation of Reverse Flow Diverter

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Numerical Investigation and Experiment on Natural Circulation Resistance and Energy Characteristics in a Circulating Axial Pump

Investigation on the Energy Exchange Characteristics of the Regenerative Flow Pump in an Automobile Fuel System

Mathematics Model and Parameter Calculation for Reverse Flow Diverter

Numerical Investigation of Negative Flow Characteristics in a Centrifugal Compressor With Vaned Diffuser and Internal Volute

Numerical Research on the Energy Loss of a Single-Stage Centrifugal Pump with Different Vaned Diffuser Outlet Diameters

NUMERICAL INVESTIGATION OF DIFFUSER FLOW FIELD AND ROTATING STALL IN A CENTRIFUGAL COMPRESSOR WITH VANED DIFFUSER

Numerical Research Of The Effect Of The Outlet Diameter Of Diffuser On The Performance And The Radial Force In A Single-Stage Centrifugal Pump

Performance and flow characteristics of a novel air bleeding aerodynamic combustor diffuser

Performance Analysis of Two-Dimensional Plane Diffusers at a Moderate Reynolds Number by Means of Unsteady RANS

A Numerical Study On The Flow Mechanism Of Performance Improvement Of A Wide-Angle Diffuser By Inserting A Short Splitter Vane

Experimental study and numerical simulation of internal flow dissipation mechanism of an axial-flow pump under different design parameters