Abstract:Adopting the traditional LMTD method to design the SS-SG (Separated Structure Steam Generator) usually leads to a larger deviation due to drastically change in physical properties of flue gas with changing temperature. This makes the consumption of steel tubes and power energy during both the manufacturing and operation processes increase. As an exploratory investigation, a novel thermal design model was developed with the idea of micro-element superposition and validated against the experiment herein. It revealed that the maximum absolute deviation between prediction and experiment was less than 2.5%, which outperformed a lot compared to the traditional method. As an application case, this model was used to design an actual steam generator in this study. The design results showed that the steel tube consumption can be reduced by 27.19%, while the power energy consumption can be saved by 11.45% for long-term operation. Using the proposed model, the effect of operating conditions on thermal performance of the steam generator was discussed. It indicated that the increase in the inlet temperature and mass flow rate of flue gas, as well as the operating pressure, generally weakens the comprehensive thermal performance indexes PEA and PEB. Besides, this novel model can also be combined with an intelligent algorithm to perform structure optimization. For this case, compared to the original structure, the total cost can be further decreased by 17.57% with the obtained optimal structure from an economic point of view. It is of great significance to improve the economics of recovering flue gas waste heat.

Inner tube optimization of double-tube once-through steam generator

Multi-objective optimization of double-tube once-through steam generator

Study on the Structure Optimization and the Operation Scheme Design of a Double-Tube Once-Through Steam Generator

Structural optimization of double-tube once-through steam generator using Pontryagin's Maximum Principle

Helical Pitch Optimization Of Double-Tube Once-Through Steam Generator

Characteristic Optimization of the Double-Tube Otsg

Primary Fluid Optimization in Once-Through Steam Generator

Heat Transfer Optimization of Once-Through Steam Generator

ICONE19-43034 Thermal Optimization of Primary Side in Double-Tube OTSG

DESIGN OPTIMIZATION OF LEAD-BISMUTH HELICAL COIL ONCE-THROUGH TUBE STEAM GENERATOR BASED ON POROUS MEDIUM METHOD

The optimum design and arrangement of a steam generator in an integral pressurized water reactor

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Numerical Analysis of the Flow Behavior in a Helically Coiled Once Through Steam Generator

Investigations On Optimal Design Of A U-Tube Steam Generator

Optimal Design of a Double Pipe Heat Exchanger Based on the Outward Helically Corrugated Tube

Development and Optimization on Separated Structure Steam Generator Based on a New Thermal Design Model

Parametric Sensitivity Analysis of Liquid Metal Helical Coil Once-Through Tube Steam Generator

Numerical Analysis of Liquid Metal Helical Coil Once-Through Tube Steam Generator

Experimental and numerical study of the thermal hydraulics characteristics of a helical-coiled once-through steam generator

Multi-objective Optimization of Helical Coil Steam Generator in High Temperature Gas Reactors with Genetic Algorithm and Response Surface Method

Multi-objective Optimization of Turbulent Heat Transfer Flow in Novel Outward Helically Corrugated Tubes