Size-controllable Synthesis and Functionalization of Ultrafine Polymeric Nanoparticles.

Mengjun Chen,Wantai Yang,Meizhen Yin

DOI: https://doi.org/10.1002/smll.201203130

IF: 13.3

2013-01-01

Small

Abstract:To date, there are numerous reports on the studies of inorganic particles within 10 nm. [ 2 ] In case of polymeric nanoparticles (PNPs), only few researches involved particles with very small sizes, [ 3 ] while the most reported sizes were larger than 10 nm. [ 4 ] So far, facile and economical preparation of PNPs smaller than 10 nm is still challenging. Microemulsion poly merization is an effective approach to hydrophobic PNPs below 100 nm. [ 5 ] Inverse microemulsion polymerization (IMP) has been used for the synthesis of hydrophilic PNPs. [ 6 ] The pioneering work can be traced to Schulman who discovered [ 7 ] and coined the term microemulsion. [ 8 ] In IMP system, sizes of hydrophilic PNPs could be controlled by varying water content in the inverse micelles, [ 9 ] where the polymerizations occurred. [ 10 ] However, the minimum of adjusted range for PNP sizes was restricted by the amount of unavoidable water when using solid monomers, e.g. acrylamide and its derivatives that have to be dissolved in water. [ 11 ] In this work, we developed an anhydrous IMP process to achieve the minimum PNP sizes by using a liquid hydrophilic monomer N,N dimethylacrylamide (DMAA). The formation of PDMAA nanoparticles via anhydrous IMP is illustrated in Figure 1 (A). Ultrafi ne PNPs of 2.6 nm were obtained in the anhydrous system. Unlike traditional IMP, the products precipitated spontaneously without addition of any demulsifi er (Figure S1). The mechanism of auto-precipitation was proposed and demonstrated. In general, the large usage of surfactant and demulsifi er in traditional IMP [ 12 ] is an obstacle to economical industrialization applications. The auto-precipitation in our modifi ed IMP avoided the contamination by impurities and