Abstract:Direct left turn (DLT) at intersection has a lot of safety and operation problems. For example, it increases traffic conflicts, delay and reduces capacity of the road network. Increasingly, Right turn plus U-turn or U-turn plus right turn (RT+UT or UT+RT) at intersection as an alternative to DLT has been considered as an important access management. Many states and transportation agencies are considering to applying the access management. However, some operation problems emerge in practical application. For example, U-turn location selection is ill-defined, experiential and short of systemic programming theory. The impact of the treatment and applicability is still not very clear in China for the different traffic conditions with overseas countries. The primary objective of the study is to examine the influence of U-turn location selection to the effectiveness of U-turn at signalized intersections under the different conditions of traffic volume and percentage left turns. And set up a set of guidelines for using this alternative in China. To achieve the objectives, firstly, the traffic character under different U-turn location is analyzed. Secondly, delay and travel time models of U-turn are proposed. Then, the microscopic traffic simulation software VISSIM is used to make simulation of the different conventional location of U-turn traffic managements under different traffic volume and percentage left turns at intersection. For the precision of simulations, the simulation parameters are calibrated by using the field observed data. The average delay is used as performance estimation parameter. The trend lines of the relationship between average delay and different traffic volume on arterials and percentage left turns was developed. Consequently, the findings of this study are helpful in providing local and state transportation agencies with recommendations for the selection of access managements and various driveway left-turn alternatives on multilane roadways. © 2009 IEEE.

Analysis of Signalized Intersection U-Turn Design Based on the Micro-Simulation Study

Research on the impact of U-turn location on operation efficiency at intersection

Traffic Signal Control Optimization Strategy Based on Simulation

Research On The Impact Of Traffic Volume On U-Turn At Intersection

Analysis om waiting area for left-turn vehicles at signalized intersections

Analysis of a Signalized Intersection with Dynamic Use of the Left-Turn Lane for Opposite through Traffic

VISSIM-Based Simulation Approach to Evaluation of Design and Operational Performance of U-turn at Intersection in China

Signal control method and performance evaluation of an improved displaced left-turn intersection design in unsaturated traffic conditions

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Procedure for Evaluating the Impacts of Indirect Driveway Left-Turn Treatments on Traffic Operations at Signalized Intersections

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

Calculation method of travel time of right-turn vehicle at motor-and nonmotor-vehicle mixed traffic intersection

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation

Inter-green interval calculation for signalized intersections

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Traffic Design and Signal Timing of Staggered Intersections Based on a Sorting Strategy

Signal control and simulation of a typical roundabout

Comparing Roundabouts and Signalized Intersections Through Multiple-Model Simulation

Location Research of Indirect Left U-Turn at Intersection Based on VISSIM Simulation

Safety and Efficiency Analysis of Turbo Roundabout with Simulations Based on the Lujiazui Roundabout in Shanghai