Abstract:Beam orbit stability is vital for the synchrotron radiation light source. Hefei Advanced Light Facility (HALF), the fourth generation diffraction limit storage ring now under preliminary research with submicron beam orbit stability, requires a beam position monitor (BPM) system with accuracy better than 100 nm. In this paper, a BPM processor with pilot tone was developed using domestic chips, which is composed of the pilot tone module, the analog frontend module, the digital processing module and the embedded control module. The input signals from BPM detector were adjusted in pilot tone module and analog frontend module, digitalized in digital processing module by bandpass sampling principle, and the digital signals were processed in FPGA (field programmable gata array) to obtain turnbyturn data, fast acquisition data (FA data) at a 10 kHz rate, and slow acquisition data (SA data) at a 10 Hz rate. The embedded control module transmitted the beam position information in real time and communicated with the accelerator control system. Thermal drifts of the channels and variations of the cables frequency response (due to changes in temperature or humidity) could introduce uncontrolled fluctuations in the position calculated. To enhance longterm stability of the BPM processor, a low phasenoise pilot tone was added to the beam signal as a reference to eliminate the effect of gain drifts of the individual channel on position calculation. The analog front end was customized with adjustable gain to increase the dynamic range of the system, and composed of four identical radiofrequency (RF) channels, each with several amplifiers, attenuators and filters to adjust the signals for ADC sampling. All beam position calculations were performed in the digital domain. The bandpass sampling technique was applied to convert narrowband RF signals into intermediatefrequency (IF) digital signals. And then the IF signals were converted to the baseband inphase and quadraturephase (IQ) data through the digital down conversion method. CIC (cascaded integrator comb) and FIR (finite impulse response) decimation filters were used to avoid highcomponent signal aliasing and decimate the IQ data rate. CORDIC (coordinated rotation digital computer) module was implemented in pipeline structure to calculate the signal amplitudes from IQ data. With four BPM signal amplitudes, the beam position could be obtained by the differenceoversum algorithm. These digital signal processing algorithms were integrated on one FPGA. At present, the laboratory offline tests and the beam tests of the designed beam position processor were carried out. The offline tests demonstrate the effectiveness of pilot tone in compensating for external changes and improving the longterm stability. The test results indicate that the resolutions of the FA data and SA data are better than 120 nm and 70 nm respectively with the input amplitudes ranging from -55 dBm to 5 dBm, which meet the design requirements.

Study of resonance driving term in electron storage rings

Development of Pilot-tone Based BPM Processor of Storage Ring

Effective Improvement of Beam Lifetime Based on Radiofrequency Phase Modulation at the HLS-II Storage Ring

Beam lifetime measurement using beam position monitor in SSRF

Application of the Turn-By-Turn Beam Position Measurements on Bepc Storage Ring

The Measurement of Tune and Phase Space at HLS

Lattice design and beam lifetime study for HLS storage ring upgrade project

Research and Measurement of BPM System at HLS LINAC

Beam Dynamics Design and Error Study of BISOL Deuteron Driver Linac

Periodic Transient Beam Loading Effect with Passive Harmonic Cavities in Electron Storage Rings

Experimental Investigation of Transverse Quadrupolar Beam Oscillation in the Hefei Light Source-II Storage Ring

Simulation studies on compensation for space-charge-induced half-integer and 3rd-order resonance crossing in HIAF-BRing

Analysis Of Some Phenomena In The Commissioning Of The Storage Ring In The Phase Ii Project Of The Hls

Bunch-length Measurement at a Bunch-by-bunch Rate Based on Time–frequency-Domain Joint Analysis Techniques and Its Application

Analysis of Some Phenomena in the Commissioning of the Storage Ring in the Phase Ⅱ Project of the HLS

New Noninvasive Measurement Method of Optics Parameters in a Storage Ring Using Bunch-by-bunch 3D Beam Position Measurement Data

Lattice design and experimental studies of nonlinear resonance at the Cornell Electron Storage Ring

HLS Turn-by-Turn System and Its Application

Recent research advances of beam diagnostic system for HLS

Measurement of Beam Steering and RF Defocusing Effect for a Quarter-Wave Resonator

Numerical Simulation Study On Spin Resonant Depolarization Due To Spin-Orbit Coupling