Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

HLS Turn-by-Turn System and Its Application

Experiment Result of the Turn-by-turn System and Its Application in HLS

New Diagnostic Systems on HL-2A

Application and Design of Photon Beam Position Monitor in HLS

The beam loss monitoring system for HLS storage ring

Analysis of Some Phenomena in the Commissioning of the Storage Ring in the Phase Ⅱ Project of the HLS

Development Of A Split Photon Beam Position Monitor For Hls

Simulation of hefei advanced light source ( hals ) injection system *

HLS Bunch-by-bunch Measurement, Transverse Feedback System and Primary Experiment Results

Application of PLC Technology in Measurement of Beam Profile on 100mev Accelerator

Beam Instrumentation System Optimization for Top-up Operation in SSRF

A Method to Calibrate Beam Position Monitor at HLS 200 MeV Linac

The system of slow beam orbit feedback for HLS

Beam Loading Effects and Intensity Limit in the Injection Process of Hefei Light Source

Conceptual Design of Hefei Advanced Light Source (hals) Injection System

Application Research of Tune Measurement System in Hefei Light Source

Physical Design of Full Energy Injection System in HLS

Tracking Simulations for the HLS- II with a Passive Harmonic Cavity in the Symmetric and Asymmetric Fill Patterns

Methods of Measurement for the Beam-Based Alignment System in HLS

Power Transmission Tower Monitoring with Hydrostatic Leveling System: Measurement Refinement and Performance Evaluation