Data for: Single nanowire spectrometers
Zongyin Yang,Tom Albrow-Owen,Hanxiao Cui,Jack Alexander-Webber,Fuxing Gu,Xiaomu Wang,Tien Chun Wu,Minghua Zhuge,Calum Williams,Pan Wang,Anatoly V Zayats,Weiwei Cai,Lun Dai,Stephan Hofmann,Mauro Overend,Limin Tong,Qing Yang,Zhipei Sun,Tawfique Hasan
2019-01-01
Abstract:Data for the plots in the main text. Instructions for some data sets are contained within the Excel file. Detailed description: One Microsoft Excel file containing data for each plot in the main manuscript figures, as labelled. Photoluminescent data (1A) is measured through 355 nm laser illumination of a typical CdSxSe1-x nanowire at 7 different locations as shown in the image in the main text; intensities for each location are normalized to their respective maximum intensity. Photocurrent measurements (1C) are made applying bias between two electrodes toward the CdSe-rich end of a typical nanowire photodetector array, under the labelled irradiances by 490 nm light. Time response (1D) is of the same unit as measured for the photocurrent data, under illumination by a blue LED, pulsed at a frequency of 50 Hz. Calibration data (1E) is supplied for each unit (labelled as R" i", where" i" is the unit index) of a typical nanowire spectrometer with 30 units, consisting of the photocurrent measured under illumination at different wavelengths from 490 to 630 nm (spaced in the case of this example at increments of 5 nm) by a tunable Xe arc lamp source. Note that for the nanowire devices presented in Figs. 2A-D, 3F and 4G, a narrower sample spacing of 3 nm was used in the calibration. Note also that calibration photocurrents have been normalised for the purpose of more clearly illustrating the spread of cut-off wavelengths across the set of units. Spectral datasets (2A-D, 3F, 4G) are, as labelled, either measured from a conventional spectrometer (Thorlabs, CCS100 compact spectrometer, 350-700 nm) or reconstructed by a 30-unit or 38-unit nanowire …