Abstract:A magnetorheological (MR) damper has been manufactured and tested and a non‐linear model is discussed. The parameters for the model are identified from an identification set of experimental data; these parameters are then used to reconstruct the force vs. displacement and the force vs. velocity hysteresis cycles of the MR damper for the hysteretic model. Then experiments are conducted on a three‐storey frame model using impact excitation, which identifies dynamic parameters of the model equipped with and without the MR damper. Natural frequencies, damping ratios and mode shapes, as well as structural properties, such as the mass, stiffness and damping matrices, are obtained. A semi‐active control method such as a variable structure controller is studied. Based on the ‘reaching law’ method, a feedback controller is presented. In order to evaluate the efficiency of the control system and the effect of earthquake ground motions, both numerical analysis and shaking table tests of the model, with and without the MR damper, have been carried out under three different ground motions: El Centro 1940, Taft 1952, and Ninghe 1976 (Tangshan Earthquake in Chinese). It is found from both the numerical analysis and the shaking table tests that the maximum accelerations and relative displacements for all floors are significantly reduced with the MR damper. A reasonable agreement between the results obtained from the numerical analysis and those from the shaking table tests is also observed. On the other hand, tests conducted at different earthquake excitations and various excitation levels demonstrate the ability of the MR damper to surpass the performance of a comparable passive system in a variety of situations. Copyright © 2003 John Wiley & Sons, Ltd.

Semi-Active Control of Adjacent Model Structures Connected with MR Dampers Using the Shaking Table

Vibration control of seismic response of adjacent buildings coupled with semi-active MR dampers

Experimental Study of the Semi‐active Control of Building Structures Using the Shaking Table

Stochastic Optimal Semi-Active Control of Stay Cables by Using Magneto-Rheological Damper

Experimental Study on Semi-Active Control of Frame-Shear Wall Eccentric Structure Using Mr Dampers

Integrated Intelligent Control Analysis on Semi-Active Structures by Using Magnetorheological Dampers

Experimental studies on nonlinear seismic control of a steel–concrete hybrid structure using MR dampers

Experiment and analysis of torsional seismic responses for asymmetric structures with semi-active control by MR dampers

Comparative Studies of Semiactive Control Strategies for MR Dampers: Pure Simulation and Real-Time Hybrid Tests

Shaking Table Tests of Magnetorheological Damped Frame to Mitigate the Response under Real-Time Online Control

Semi-Active Control of Structures Incorporated with Magnetorheological Dampers Using Neural Networks

Sliding-mode-based semi-active control for oscillations of structures

The Shaking Table Test of Semi-Active Varying Damping Structure

Semi-Active Control of Smart Building-Mr Damper Systems Using Novel Tsk-Inv and Max-Min Algorithms

Comparative Study of Semi-Active Control Effectiveness of Structures on Soft Soil Using MR Damper: Shaking Table Investigation

New magnetorheological damper and its application in semi-active control of structural seismic response

New Type Magnetorheological Damper And Its Application On Semi-Active Control Of Structural Seismic Response

Semi-Active Control for Benchmark Building Using Innovative TMD with MRE Isolators

New semi-active control strategy for vibration suppression of high-rise building

MR Dampers-Based Semi-Active Control Strategy of Cable-Stayed Vibration

Semi-active control for eccentric structures with MR damper by hybrid intelligent algorithm