Abstract:The employment of aftertreatment systems in modern diesel engines has become indispensable to meet the stringent emissions regulations. However, a minimum exhaust gas temperature of approximately 200 °C must be reached to initiate the emissions control operations. Low-load engine operations usually result in relatively low exhaust gas temperature, which lead to reduced or no exhaust emissions conversion. In this context, this study investigated the use of different combustion control strategies to explore the trade-off between exhaust gas temperature, fuel efficiency, and exhaust emissions. The experiments were performed on a single-cylinder heavy-duty diesel engine at a light load of 2.2 bar indicated mean effective pressure. Strategies including the late intake valve closing timing, intake throttling, late injection timing (T inj ), lower injection pressure (P inj ), and internal exhaust gas recirculation and external exhaust gas recirculation were investigated. The results showed that the use of external exhaust gas recirculation and lower P inj was not effective in increasing exhaust gas temperature. Although the use of late T inj could result in higher exhaust gas temperature, the delayed combustion phase led to the highest fuel efficiency penalty. Intake throttling and internal exhaust gas recirculation allowed for an increase in exhaust gas temperature at the expense of higher fuel consumption. In comparison, late intake valve closure strategy achieved the best trade-off between exhaust gas temperature and net indicated specific fuel consumption, increasing the exhaust gas temperature by 52 °C and the fuel consumption penalty by 5.3% while reducing nitrogen oxide and soot emissions simultaneously. When the intake valve closing timing was delayed to after −107 crank angle degree after top dead centre, however, the combustion efficiency deteriorated and the HC and CO emissions were significantly increased. This could be overcome by combining internal exhaust gas recirculation with late intake valve closure to increase the in-cylinder combustion temperature for a more complete combustion. The results demonstrated that the ‘late intake valve closure + internal exhaust gas recirculation’ strategy can be the most effective means, increasing the exhaust gas temperature by 62 °C with 4.6% fuel consumption penalty. Meanwhile, maintaining high combustion efficiency as well as low HC and CO emissions of diesel engines.

Closed-loop control of low temperature combustion and transition process of diesel engine

Closed-loop control of low temperature combustion in diesel engines with cylinder pressure information

Development and Experimental Study of Cycle-Based Combustion Control System

Stability Control Methods of Low-temperature PCCI for Diesel Engine

Control strategy of combustion modes switch for diesel engine

Simulation and Optimization of Low Temperature Combustion in Diesel Engine at High Load

Research on Close-Loop Control Strategy of Diesel Engine Based on In-Cylinder Pressure

On improving the controllability of low-temperature combustion by building two-stage sequential high-temperature reactions in an ethanol/diesel dual-fuel engine using multiple injections

Optimal control of oil-gas switch process of CNG/diesel dual fuel engine

Study on Diesel Engine Coolant Temperature Control Strategy with Feedforward

Closed-loop combustion phase control for multiple combustion modes by multiple injections in a compression ignition engine fueled by gasoline-diesel mixture

Exploring alternative combustion control strategies for low-load exhaust gas temperature management of a heavy-duty diesel engine

Experimental Research on Low Temperature Combustion under Coupled Effect of EGR Rate and Intake Temperature

Fuel injection and EGR control strategy on smooth switching of CI/HCCI mode in a diesel engine

Experimental Investigation of Combustion Characteristics Analysis and Optimization During the Turbocharging Mode Switching Process of Diesel Engine with Advanced Turbocharging System

Closed-loop Control for Diesel Engine Air Systems Equipped with Vacuum Actuators

Design and Experiment of Control System for EGR Cooling System on Diesel Engine

Research Progress on Low Temperature Combustion of Diesel Engine

Experimental Investigation of Low-Temperature Combustion (ltc) in an Engine Fueled with Dimethyl Ether (Dme)

Experimental study of the combustion characteristics prediction model for a sensor-less closed-loop control in a heavy-duty NG engine

Closed-Loop Diesel Combustion Control Leveraging Ignition Assist