Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Trapping efficiency model of fibrous DPF based on fractal theory

Lumped model for evaluating dynamic filtration and pressure drop behaviour in diesel particulate filters

Numerical simulation of diesel particulate filter flow characteristics optimization: From the perspective of pore structure parameters and inlet velocity

Study of the Influence of Methanol/f-T Diesel Combustion Particle Materiality Parameters on the Deposition Process in Diesel Particulate Filter Trap Units

Effect of structural parameters on diesel particulate filter trapping performance of heavy-duty diesel engines based on grey correlation analysis

Novel soot loading prediction model of diesel particulate filter based on collection mechanism and equivalent permeability

Single wall diesel particulate filter (DPF) filtration efficiency studies using laboratory generated particles

Simulative Prediction of Ultrafine Particulate Matter Formation by Means of Different Pyrolysis Models

Extended filtration model for diesel particulate filter based on diesel particulate matter morphology characteristics

A Method of Improving of Capture Efficiency of Radial Diesel Particulate Filter

Filtration efficiency analysis of fibrous filters: Experimental and theoretical study on the sampling of agglomerate particles emitted from a GDI engine

Analysis of the effect of particle–wall collision process in DPF on the spatial structure of smoke cake layer

Experimental Study on the Influence of DPF Micropore Structure and Particle Property on Its Filtration Process

Effects of carrier structure parameters on diesel particulate filter capture performance based on grey relational analysis

A dual-geometry pore-size-resolved model to predict deep-bed loading in a wall-flow filter

Experimental Investigation on the Influence of Filtration Velocity on Particulate Deposition Characteristics in DPF

Simulation of soot particle deposition inside porous walls based on lattice Boltzmann method for diesel particulate filter

The pressure drop of fibrous surface filters for gas Filtration: Modeling and experimental studies

Research on Dynamic Modeling and Carbon Load Estimation of Diesel Particulate Filter

Equipment and diesel particulate trap DPF based on accurate regeneration of DPF is realized to radio frequency technology control carbon cumulant

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution