Flow properties and extrudate swell during extrusion of polycaprolactone melt

Fengjiao Li,Jia Yang,Lin Zhou,Yukun Zhang,Jizhao Liang
DOI: https://doi.org/10.3969/j.issn.1002-1396.2012.06.015
2012-01-01
Abstract:The influences of temperature, apparent shear rate(γa) and channel wall shear stress (τR) on the flow properties and extrudate swell ratio of polycaprolactone (PCL) melt were studied by means of a melt flow rate instrument under load ranging from 2.16 kg to 12.50 kg at 90-140°C. The results show that the shear flow of PCL melt substantially follows the power law under the experimental conditions. The relation between the melt apparent shear viscosity (ηa) and absolute temperature corresponds with the Arrhenius equation; ηa values decrease non-linearly with the increase in γa or τR. The extrudate swell ratio (B) reduces non-linearly with the rise in temperature, but increases non-linearly with augment in γa or τR and then declines after reaching its maximum value.
What problem does this paper attempt to address?