Abstract:Oceanic cobalt‐rich crusts contain many valuable metals including Co, Ni, Cu, and Mn, of which Co and Ni are scarce metal resources on terrestrial land. Co, Ni, Cu, and Mn in cobalt‐rich crusts can be efficiently extracted by the ammonium sulfate roasting‐water leaching (ARWL) process, but separating and recovering Co and Ni from the leaching solution containing high concentrations of Mn is a challenging problem. In this study, a combination of sulfide precipitation and P507–Cyanex 272 synergistic extraction is proposed for the separation and recovery of Co and Ni from the ARWL solutions of oceanic cobalt‐rich crusts. Under the optimum sulfide precipitation conditions, Co and Ni were precipitated with 99.85% and 99.63% efficiency, respectively, while Mn was coprecipitated with only .79% efficiency. The Co–Ni mixed sulfides were dissolved by dilute sulfuric acid under oxidative conditions to obtain a solution containing 12.584 g/L Co, 11.012 g/L Ni, and a small amount of Mn. Subsequently, Co and Mn were extracted from this solution using P507–Cyanex 272 synergistic extraction, the single‐stage extraction efficiencies of Co and Mn were 95.76% and 99.73%, respectively, and the coextraction efficiency of Ni was 3.02%, under the conditions of a feed solution pH of 3.0, an extractant saponification degree of 70%, a total extractant concentration of 20% (P507 to Cyanex 272 ratio of 3:7), and an O/A ratio of 1.1:1. The results of the thermodynamic study showed that the reaction of Co extraction by this mixed extraction system was exothermic. Ni in the organic phase was washed with an H2SO4 concentration of .12 mol/L, followed by stripping of Co and Mn with an H2SO4 concentration of .6 mol/L. Mn in the stripping solution was removed by oxidative precipitation with (NH4)2S2O8, after which the Co3O4 product was obtained by precipitation with (NH4)2C2O4 and calcination. Similarly, NiC2O4·2H2O can be obtained from the raffinate by (NH4)2C2O4 precipitation. Finally, a flowsheet was developed for the separation and recovery of Co, Ni, Cu, and Mn from the ARWL solutions of oceanic cobalt‐rich crusts. The study provides a promising scheme for the recovery of various valuable metals from deep‐sea cobalt‐rich crusts or manganese nodules.

Novel Process of Selective Extraction of Copper and Cobalt from Heterogenite

Recovery of Copper and Cobalt from Low-Grade Heterogenite with Reductive Acid Leaching Method

Extractive Separation of Copper and Cobalt from Acid Leaching Solution of Heterogenite by Using Lix984

Recovery of Metal Values from Low-Grade Heterogenite with Reductive Ammonia Leaching Method

Selective extraction performance of Ni, Cu, Co, and Mn adopted by a coupled leaching of low-grade Ni-sulfide ore and polymetallic Mn-oxide ore in sulphuric acid solutions

Solvent extraction-based recovery of Co from leach solutions of Cu Co ores using a Mextral 6103H-naphthenic acid- isooctanol system

Recovery of Pure Co(II) and Ni(II) Solutions from Synthetic Sulfate Leach Liquor of Laterite Ores by Precipitation and Solvent Extraction

Optimization Study of Operation Parameters for Extracting \hbox {Cu}^{2+} from Sulfuric Solution Containing \hbox {Co}^{2+} with LIX984N in a Laminar Microchip

Separation of cobalt and nickel via solvent extraction with Cyanex-272: Batch experiments and comparison of mixer-settlers and an agitated column as contactors for continuous counter-current extraction

Development of a conceptual direct solvent extraction (DSX) route to produce purified concentrated cobalt and nickel solutions representing sulfuric acid leach liquor of laterite

Simultaneous dissolution of nickel, copper and cobalt from low grade nickel matte by (NH4)2S2O8-H2SO4 oxidative leaching

Characterization and Optimization of Copper-Cobalt Oxide Ores During Acid Leaching

Study on the mineral processing technology of a high Ca-Mg contents and sulphide-oxide mixed copper-cobalt ore in Congo (Kinshasa)

Efficient separation and recovery of Co and Ni from ammonium sulfate roasting‐water leaching solutions of oceanic cobalt‐rich crusts by sulfide precipitation and P507–Cyanex 272 synergistic extraction

Understanding and controlling the key phase transformation for selective extracting Ni and Cu from Cr-containing electroplating sludge

Optimization Study Of Operation Parameters For Extracting From Sulfuric Solution Containing With Lix984n In A Laminar Microchip

Processing of copper converter slag for metal reclamation. Part I: Extraction and recovery of copper and cobalt

Optimization Study of Operation Parameters for Extracting Cu^2+ from Sulfuric Solution Containing Co^2+ with LIX984N in a Laminar Microchip

Optimizing the Leaching Parameters and Studying the Kinetics of Nickel and Cobalt Recovery from Xinjiang Nickel–Cobalt Slag

Processing of Waste Copper Converter Slag Using Organic Acids for Extraction of Copper, Nickel, and Cobalt

Selective Removal of Transient Metal Ions from Acid Mine Drainage and the Possibility of Metallic Copper Recovery with Electrolysis