Fill Factor Enhancement of Organic Solar Cells Based on a Wide Bandgap Phosphorescent Material and C60

Junsheng Yu,Yue Zang,Haiqiang Li,Jiang Huang

DOI: https://doi.org/10.1016/j.tsf.2012.07.022

IF: 2.1

2012-01-01

Thin Solid Films

Abstract:Planar heterojunction organic solar cells using wide bandgap phosphorescent material bis[2-(4-tertbutylphenyl)benzothiazolato-N,C2'] iridium (acetylacetonate) [(t-bt)2Ir(acac)] as electron donor and fullerene (C60) as electron acceptor were fabricated. A large open circuit voltage of 0.94 V was achieved due to low highest occupied molecular orbital level of (t-bt)2Ir(acac). The effect of different hole transport layers and substrate heating were investigated to improve fill factor. It is shown that the open circuit voltage is strongly influenced by the interface energy barrier, whereas the fill factor is mainly limited by the charge carrier transport properties in active materials. The fill factor was significantly improved by either using hole transport layer with high carrier mobility or increasing the hole mobility of (t-bt)2Ir(acac). A power conversion efficiency of 2.10% under AM 1.5 solar illumination at an intensity of 100 mW/cm2 was achieved by heating the substrate during the deposition of active materials.