Separation of Waste Polymethyl Methacrylate and Polyvinyl Chloride Mixtures by Flotation after Fenton Oxidation
Jianchao Wang,Hui Wang,Dongbei Yue
DOI: https://doi.org/10.1016/j.jclepro.2019.04.349
IF: 11.1
2019-01-01
Journal of Cleaner Production
Abstract:This study provides a novel method, Fenton oxidation combined with flotation, to facilitate separation of waste polymethyl methacrylate and polyvinyl chloride mixtures for recycling. Fenton oxidation was found to induce selective surface hydrophilization of polymethyl methacrylate and suppress its flotation recovery in flotation, thereby facilitating its flotation separation with polyvinyl chloride. The surface hydrophilization occurred on polymethyl methacrylate surface was confirmed by the contact angle that decreased from 95.80 degrees to 73.11 degrees, and was attributed to the changes in surface hydrophilic groups and morphology. Scanning electron microscopy images revealed the formation of uniformly micrometer scale spotted-structures on polymethyl methacrylate surface. X-ray photoelectron spectroscopy and Fourier transform infrared spectroscopy ascertained the obvious increase of elemental ratio of O/C and the introduction of hydrophilic groups (carbonyl and hydroxyl). The optimized conditions obtained for separation of polymethyl methacrylate and polyvinyl chloride mixtures were [H2O2]/[Fe2+] ratio of 3000, hydrogen peroxide concentration of 0.2 M, reaction time of 6.0 min, pH of 5.80, reaction temperature of 25.0 degrees C, flotation time of 3.0 min, frother dosage of 14.8 mg/L, and airflow rate of 6.0 mi./min. Under optimized conditions, for the samples with particle size of 0.9-4.0 mm, the recovery and the purity of polyvinyl chloride were 100% and 97.61%, and the recovery and the purity of polymethyl methacrylate were 97.55% and 100%, respectively. Particularly for the particle size of 3.2-4.0 mm, the purity and recovery of polyvinyl chloride and polymethyl methacrylate all reached up to 100%. Reusing of Fenton and flotation solutions was evaluated, and results indicated they can be used at least 3 and 5 times, respectively. Besides, a simple economic analysis demonstrated that this method is economically feasible. In conclusion, this environmentally friendly, sustainable, and economically feasible method contributes to improve the recycling quality of waste plastics, and provides technological insights in the cleaner and sustainable disposal of waste plastics. (C) 2019 Elsevier Ltd. All rights reserved.